P2262

P2262 on a 2013–2024 Ram 2500: Turbocharger boost pressure not detected - mechanical

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P2262 on a 2013–2024 Ram 2500

DIY difficulty 4/5

Your turbo isn't making any boost at all - it's a mechanical failure, not a sensor glitch. The car will feel like the turbo isn't even there.

Model notes: Never install a replacement turbo without a new oil feed line and verifying oil supply - most repeat turbo failures are oil starvation, not bad luck.

Key facts

☑ Before you buy parts — check these first:
On your 2013–2024 Ram 2500 (6.7L Cummins I6 diesel) — 6.7L Cummins VGT soot-sticking / P2262 (exhaust brake hangs, no boost): Owner-verified
Driveway diagnosis first: scan the codes, check the actuator harness and connectors for damage, and try the cleaning step before buying a turbo. Pulling the turbo for a full clean is the bigger job — plan a weekend.
Do this test first: Remove the intake pipe and check the turbo shaft for play and seizure - it should spin freely with minimal play
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P2262 on the 2013–2024 Ram 2500 — but the community-sourced 6.7L Cummins VGT soot-sticking / P2262 (exhaust brake hangs, no boost) note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: RamForum — exhaust brake stuck on: soot buildup inside the VGT vanes, tight tolerances, Mopar cleaning solution method · RamForum — low boost uphill, no codes: Mopar 68044565AB turbocharger cleaner for soot deposits · FCA TSB 08-272-26 — air-handling performance: P2262-00 listed among 6.7L Cummins MIL codes (PDF)

Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Remove the intake pipe and check the turbo shaft for play and seizure - it should spin freely with minimal play Tests: Seized turbocharger (most common - check shaft play)
  2. Pressure-test the entire charge system for massive leaks Tests: Massive boost leak - blown intercooler hose or pipe
  3. Check that the wastegate is not stuck open Tests: Wastegate stuck fully open
  4. If the turbo is seized, find why before replacing: oil starvation from a clogged feed line kills replacement turbos too

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2013–2024 Ram 2500: 6.7L Cummins VGT soot-sticking / P2262 (exhaust brake hangs, no boost) — test first, then buy for this job.
The price range below is a national planning range for P2262 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$60 – $400
Labor$100 – $400

Valve or hose fix is typical; turbo replacement is far more. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2262 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Turbo mechanical diagnosis is straightforward; replacement is involved and demands clean oil supply.

Watch this repair on YouTube

Parts & tools

Intake & throttle toolkit — what the job actually takes

Torque specs: Throttle body bolts: typically 8–12 Nm — verify spec.

Pro tip: Some cars need a throttle relearn after cleaning (scan tool or battery-disconnect procedure), or the idle will hunt.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →