P0237: Turbocharger boost pressure sensor A circuit low
DIY difficulty 2/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonBoost faults trigger limp mode to protect the engine. Avoid hard acceleration until diagnosed.
The boost sensor is reading near zero, so the computer thinks the turbo isn't working. It may overwork the turbo trying to compensate or just give up into limp mode.
VW/Audi note (VCDS): The unplug test separates sensor faults from harness shorts in seconds on any 5V sensor circuit.
Model notes: A boost sensor reading zero while the turbo audibly spools is obviously lying - but check the wiring before buying the sensor.
Key facts
P0237 means turbocharger boost pressure sensor A circuit low. The boost sensor is reading near zero, so the computer thinks the turbo isn't working. It may overwork the turbo trying to compensate or just give up into limp mode. WrenchFair's published fair-price range for this repair is $60–$400 parts and $100–$400 labor at independent shops.
WrenchFair rates P0237 a 2-of-5 DIY difficulty (“Low circuit usually means wiring - the unplug test narrows it fast.”) with a “Diagnose soon” driveability rating: Boost faults trigger limp mode to protect the engine. Avoid hard acceleration until diagnosed. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
limp mode
low power
check engine light
possible turbo overspeed if the ECM overcompensates
reduced fuel economy
Likely causes
Signal wire shorted to ground or open (most common)
Failed sensor
Completely clogged sensor port
Corroded connector
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Unplug the sensor - if the reading jumps to the high default, the sensor is bad; if it stays low, the wiring is shorted Tests: Signal wire shorted to ground or open (most common)
Check the 5V reference and ground
Inspect the port for complete blockage
Replace the sensor only after wiring is proven good
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$60 – $400
Labor$100 – $400
Valve or hose fix is typical; turbo replacement is far more. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0237 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Low circuit usually means wiring - the unplug test narrows it fast.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →