Diagnose soonThe car can die without warning once the battery depletes - get the charging system tested promptly.
Your car's electrical system voltage is too low. Usually a dying alternator or battery - and it can strand you when the battery runs out.
Model notes: Measure voltage at the battery with the engine running (13.8-14.4V) and again at idle with electrical loads on. Voltage-drop test the cables.
Key facts
P0562 means system voltage low. Your car's electrical system voltage is too low. Usually a dying alternator or battery - and it can strand you when the battery runs out. WrenchFair's published fair-price range for this repair is $100–$500 parts and $100–$350 labor at independent shops.
WrenchFair rates P0562 a 2-of-5 DIY difficulty (“Alternator access varies by engine.”) with a “Diagnose soon” driveability rating: The car can die without warning once the battery depletes - get the charging system tested promptly. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 374 factory bulletins on file for this vehicle (mostly Electrical System, Equipment, Power Train) — see the latest ones
On your 2010–2019 Subaru Outback (2.5L EJ25, 2.5L FB25) — Battery replacement:Owner-verified
The 12V battery (Group 25; ~356 CCA OEM) sits in the front of the engine bay on the driver side, secured by a hold-down bracket. Tools: 10mm socket/ratchet, terminal brush, gloves. Disconnect the NEGATIVE cable first, then the positive (keeps a wrench slip from shorting to ground). Remove the hold-down bracket bolts, lift the old battery straight up by its handle or from the bottom, and clean the tray and terminal clamps with a brush. Set the new battery in, reinstall and snug the hold-down bracket, then connect POSITIVE first, then negative, and snug the clamps. Use a 9V memory saver if you want to keep presets.
Do this test first: Measure voltage at the battery running (13.8-14.4V) and at idle with loads on
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0562 on the 2010–2019 Subaru Outback — but the community-sourced Battery replacement note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Battery terminal clamp / hold-down bolts: verify — Snug to spec; confirm against factory service info for this vehicle — overtightening cracks the battery post.
Tips
Expect rough/high/low or hunting idle after reconnecting — the electronic throttle must relearn. Subaru idle relearn: turn off lights, A/C, stereo; reconnect battery; key to ON for 10–15 seconds without starting so the throttle body finds its home position; start and idle 10 minutes with no load, never touching the accelerator; shut off 20 seconds; key to ON 10–15 seconds; idle another 5 minutes; then test-drive. A dealer-recommended simpler version is a 15–20 minute uninterrupted idle.
Driver-side power-window auto up/down and the passenger windows may need reset (hold each switch) after a disconnect.
Radio presets and trip data are lost; there is no radio security code on these Outbacks.
Owners commonly upgrade to a higher-CCA Group 25 battery — weak batteries are a known complaint on 2015–2016 Outbacks.
Typical difficulty: Involved — based on 854 code guides for the battery repair area (an area-level estimate, not this exact job).
Typical time: “Subaru idle relearn: turn off lights, A/C, stereo; reconnect battery; key to ON for 10–15 seconds without starting so the throttle body finds its home position; start and idle 10 minutes with no load, never touching the…” — as written in the note. First-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
battery light
dim lights
multiple warning lights
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failing alternator 40 owner notes link this repair to P0562
Weak battery 40 owner notes link this repair to P0562
Corroded positive cable
Slipping/worn serpentine belt
Owner notes linked to P0562: 41 across 2 repairs — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 2 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Measure voltage at the battery running (13.8-14.4V) and at idle with loads on Tests: Weak battery
Voltage-drop test the cables
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2010–2019 Subaru Outback: Battery replacement — test first, then buy for this job.
The price range below is a national planning range for P0562 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$100 – $500
Labor$100 – $350
Battery is ~$150-250; alternator replacement runs more. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0562 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →