Diagnose soonIf the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter.
The ignition coil for cylinder 1 has an electrical fault.
Key facts
P0351 means ignition coil 'A' primary/secondary circuit. The ignition coil for cylinder 1 has an electrical fault. WrenchFair's published fair-price range for this repair is $40–$150 parts and $50–$150 labor at independent shops.
WrenchFair rates P0351 a 2-of-5 DIY difficulty (“Swap the coil with another cylinder - if the code follows, the coil is bad.”) with a “Diagnose soon” driveability rating: If the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 667 factory bulletins on file for this vehicle (mostly Equipment, Electrical System, Engine) — see the latest ones
On your 2013–2019 Subaru Outback (2.5L FB25) — Spark plugs and ignition coils:Owner-verified
The FB25 is coil-on-plug, but the signature boxer problem remains: plugs sit on the sides of the block facing the frame rails, with the rear-most plugs tight against the firewall. Work from the sides of the engine bay — disconnect the battery ground, remove the air intake duct and resonator chamber, then the air filter box for passenger-side access. Unplug each coil connector, unbolt the coil, and slide it straight out (the rear coils only clear the frame rail in one orientation — twist-and-lift, and note the angle for reinstall). Use a 5/8-inch spark plug socket with short extensions and a swivel/u-joint; fit a torque wrench where the rail allows, otherwise seat by hand and snug carefully. OEM plug is NGK SILZKAR7B11 (Subaru 22401AA781; NGK stock #93482), pre-gapped 0.039–0.043". All four plugs are done from the engine bay — no wheel or fender-liner removal is part of the documented procedure; the difficulty is extensions and angle against the rail.
Do this test first: Swap coil A with another cylinder's coil
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0351 on the 2013–2019 Subaru Outback — but the community-sourced Spark plugs and ignition coils note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Spark plug: 17.5 N·m (12.9 ft-lb) — From the 2013 Legacy/Outback FSM, ignition section (FB25).
Ignition coil mounting bolt: 8.5 N·m (6.3 ft-lb) — From the 2013 Legacy/Outback FSM; degrease coil seat and bolt first per manual.
Tips
Start plugs by hand to avoid cross-threading; the FSM torque applies to dry threads — reduce by about one-third if using anti-seize.
Check plug gap 0.039–0.043" before installing; do not re-gap iridium plugs by prying on the electrode.
Reconnect each coil connector until it clicks; a loose connector sets a coil primary circuit code.
Do all four plugs at once — iridium service interval means you won't be back for ~100k miles.
Typical difficulty: Easy — based on 64 code guides for the ignition repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light (may flash)
misfire on cylinder 1
rough idle
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failed ignition coil A (most common) 11 owner notes link this repair to P0351
Damaged wiring or corroded connector
Failed coil driver in the ECM
Owner notes linked to P0351: 11 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Swap coil A with another cylinder's coil
Check the coil connector for corrosion Tests: Damaged wiring or corroded connector
Test coil power and ground
Replace the coil if the fault follows it
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2013–2019 Subaru Outback: Spark plugs and ignition coils — test first, then buy for this job.
Expensive fork: Fuel injector, then compression test — if the misfire stays on the same cylinder after a fresh plug and a swapped coil.
The price range below is a national planning range for P0351 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$40 – $150
Labor$50 – $150
Ignition coil replacement (coil A). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0351 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Swap the coil with another cylinder - if the code follows, the coil is bad.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →