2013–2019 Subaru Outback

Community-sourced DIY repair guides for the 2013–2019 Subaru Outback, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.

Owner-verified repair guides

Spark plugs and ignition coils Owner-verified (2.5L FB25)

The FB25 is coil-on-plug, but the signature boxer problem remains: plugs sit on the sides of the block facing the frame rails, with the rear-most plugs tight against the firewall. Work from the sides of the engine bay — disconnect the battery ground, remove the air intake duct and resonator chamber, then the air filter box for passenger-side access. Unplug each coil connector, unbolt the coil, and slide it straight out (the rear coils only clear the frame rail in one orientation — twist-and-lift, and note the angle for reinstall). Use a 5/8-inch spark plug socket with short extensions and a swivel/u-joint; fit a torque wrench where the rail allows, otherwise seat by hand and snug carefully. OEM plug is NGK SILZKAR7B11 (Subaru 22401AA781; NGK stock #93482), pre-gapped 0.039–0.043". All four plugs are done from the engine bay — no wheel or fender-liner removal is part of the documented procedure; the difficulty is extensions and angle against the rail.

Typical difficulty: Easy — based on 64 code guides for the ignition repair area (an area-level estimate, not this exact job).

Torque specs

Tips

Sources: 2013 Legacy/Outback FSM — Ignition, Spark Plug (torque specs, FB25) · YouTube — How to Replace Spark Plugs on a 2017 Subaru Outback (part numbers, gap, torque) · YouTube — TRQ: How to Replace Spark Plugs 2010-2014 Subaru Outback

P0300 on this Subaru Outback — full diagnosis guide →

No owner reports yet — fixed this yourself? tell us how

Head gasket replacement Owner-verified (2.5L FB25 DOHC)

Head-gasket failure on the FB25 is rare — confirm the diagnosis before wrenching, because external oil weep at the head/block seam on a high-mileage engine is often just seepage, and leaking cam-carrier RTV seals are the more common oil leak on these engines. If you do the job, pull the engine: even the cam-carrier reseal requires engine removal, and heads come off far more cleanly on a stand. The FB25 uses a timing chain, so there is no timing-belt job to bundle in as there is on the EJ.

Torque specs

Tips

Sources: TheSubaruForums — 2014 FB25 head gasket vs cam-carrier seal diagnosis · UltimateSubaru — Outback EJ25 (2010–2012) vs FB25 (2013+) timeline, oil-consumption note · UltimateSubaru — FB engine timing-chain introduction years · YouTube (speedkar99) — FB25 teardown: fewer head-gasket failures than EJ, valve-spring and oil-consumption issues · LegacyGT — 2013 Subaru head gaskets / FB coolant routing change

P0301 on this Subaru Outback — full diagnosis guide →

No owner reports yet — fixed this yourself? tell us how

Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

Codes on this Outback

P0300
2013–2019 Subaru Outback
Spark plugs and ignition coils
P0301
2013–2019 Subaru Outback
Spark plugs and ignition coils
P0302
2013–2019 Subaru Outback
Spark plugs and ignition coils
P0303
2013–2019 Subaru Outback
Spark plugs and ignition coils
P0304
2013–2019 Subaru Outback
Head gasket replacement
P0351
2013–2019 Subaru Outback
Spark plugs and ignition coils
P0420
2013–2019 Subaru Outback
Head gasket replacement

What owners report

NHTSA recorded 642 complaints for the 2013–2019 Subaru Outback. 2016 was the worst year (642 complaints). Most-reported areas: electrical system, unknown or other, visibility/wiper.

Counts are NHTSA complaints filed for these model years, via the NHTSA API. See data for all Outback years →

Recalls

4 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.

Factory service bulletins

NHTSA has published 1,308 manufacturer communications (service bulletins, dealer notices) covering the 2013–2019 Subaru Outback.

Most cited systems: Equipment (586), Electrical System (484), Engine (103), Power Train (98), Engine And Engine Cooling (85).

Latest bulletins:

NHTSA also opened 1 defect investigation covering these years.

Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.

Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.