P0351-P0356

P0351-P0356: Ignition coil 'A' primary/secondary circuit

DIY difficulty 2/5

The wiring or circuit for one ignition coil has an electrical fault. The car will misfire - start with the coil connector before assuming the worst.

VW/Audi note (VCDS): Wiggle-test the coil harness with the engine running while watching live data for dropouts.
Model notes: Start with the coil connector - corrosion, spread pins, or oil contamination cause many of these. Cylinder numbering varies by manufacturer; check a diagram for your engine.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 3 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Inspect the coil connector for corrosion, spread pins, or oil contamination Tests: Corroded or damaged coil connector
  2. Check wiring continuity from the coil to the ECM
  3. Try a known-good coil before condemning wiring

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$25 – $80
Labor$80 – $200

Often just a coil or connector repair; harness faults cost more in labor. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

DIY difficulty

2 of 5 — Connector inspection is easy; chasing harness breaks is tedious.

Watch this repair on YouTube

Parts & tools

Spark plug & coil toolkit — what the job actually takes

Torque specs: Gasket-seat plugs: typically 20–30 Nm (15–22 lb-ft). Tapered-seat plugs: typically 11–18 Nm. Always verify against your engine’s factory spec — over-torquing strips aluminum threads.

Pro tip: Blow out the plug wells with compressed air BEFORE removing the plugs, so debris can’t fall into the cylinders.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →