Diagnose soonMisfires can damage the catalytic converter. Drive gently; if the check-engine light is flashing, stop driving.
The wiring or circuit for one ignition coil has an electrical fault. The car will misfire - start with the coil connector before assuming the worst.
VW/Audi note (VCDS): Wiggle-test the coil harness with the engine running while watching live data for dropouts.
Model notes: Start with the coil connector - corrosion, spread pins, or oil contamination cause many of these. Cylinder numbering varies by manufacturer; check a diagram for your engine.
Key facts
P0351-P0356 means ignition coil 'A' primary/secondary circuit. The wiring or circuit for one ignition coil has an electrical fault. The car will misfire - start with the coil connector before assuming the worst. WrenchFair's published fair-price range for this repair is $25–$80 parts and $80–$200 labor at independent shops.
WrenchFair rates P0351-P0356 a 2-of-5 DIY difficulty (“Connector inspection is easy; chasing harness breaks is tedious.”) with a “Diagnose soon” driveability rating: Misfires can damage the catalytic converter. Drive gently; if the check-engine light is flashing, stop driving. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
misfire
check engine light
rough running
Likely causes
Failed ignition coil
Corroded or damaged coil connector
Broken wire in the coil harness
ECM driver fault (rare)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 3 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Inspect the coil connector for corrosion, spread pins, or oil contamination Tests: Corroded or damaged coil connector
Check wiring continuity from the coil to the ECM
Try a known-good coil before condemning wiring
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$25 – $80
Labor$80 – $200
Often just a coil or connector repair; harness faults cost more in labor. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →