P0307-P0312

P0307-P0312: Cylinder 7 misfire detected

DIY difficulty 2/5

One specific cylinder in your V8 or larger engine isn't firing properly. The good news: the code tells you exactly which cylinder, which makes this one of the easier problems to track down.

VW/Audi note (VCDS): Misfire counters per cylinder are the key PID - confirm the code's cylinder is actually the one misfiring before swapping parts.
Model notes: On V8/V10/V12 engines, rear cylinders run hotter and coils there fail first. A flashing check engine light means catalyst-damaging misfire - ease off the throttle and fix it soon.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Note the exact cylinder from the code, then check misfire counters in live data to confirm that cylinder dominates Tests: Failed ignition coil on the indicated cylinder (most common)
  2. Swap the coil from the misfiring cylinder to a good cylinder - if the misfire follows the coil, replace the coil Tests: Failed ignition coil on the indicated cylinder (most common)
  3. If the coil is innocent, swap the spark plug the same way Tests: Worn or fouled spark plug on the indicated cylinder
  4. If ignition parts are ruled out, run a compression test on the suspect cylinder - low compression means mechanical problems, not ignition Tests: Failed ignition coil on the indicated cylinder (most common)

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$30 – $120
Labor$80 – $180

Coils and spark plugs are the typical fix. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

DIY difficulty

2 of 5 — Cylinder-specific codes make this one of the most DIY-friendly diagnostics - swap parts between cylinders to confirm before buying.

Watch this repair on YouTube

Parts & tools

Spark plug & coil toolkit — what the job actually takes

Torque specs: Gasket-seat plugs: typically 20–30 Nm (15–22 lb-ft). Tapered-seat plugs: typically 11–18 Nm. Always verify against your engine’s factory spec — over-torquing strips aluminum threads.

Pro tip: Blow out the plug wells with compressed air BEFORE removing the plugs, so debris can’t fall into the cylinders.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →