Diagnose soonDrivable, but boost control and fueling suffer - diagnose soon.
The sensor measuring intake manifold pressure is giving implausible readings. Usually a cheap, easy sensor swap.
VW/Audi note (VCDS): Key-on-engine-off MAP vs barometric pressure comparison is a 30-second sanity check.
Model notes: Quick sanity check: with key on and engine off, the MAP reading should nearly match barometric pressure. Also inspect the sensor port for carbon/oil blockage.
Key facts
P0106 means manifold absolute pressure sensor circuit range/performance. The sensor measuring intake manifold pressure is giving implausible readings. Usually a cheap, easy sensor swap. WrenchFair's published fair-price range for this repair is $30–$120 parts and $50–$150 labor at independent shops.
WrenchFair rates P0106 a 1-of-5 DIY difficulty (“Usually one bolt and a connector.”) with a “Diagnose soon” driveability rating: Drivable, but boost control and fueling suffer - diagnose soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 2,804 factory bulletins on file for this vehicle (mostly Equipment, Electrical System, Engine And Engine Cooling) — see the latest ones
On your 2011–2014 Volkswagen Jetta (2.5L inline-5 (07K)) — PCV diaphragm failure (rough idle / P0106):Owner-verified
The PCV system is built into the valve cover on the 2.5L five-cylinder. The failure-prone part is a round rubber diaphragm under a cap on top of the valve cover, reachable without removing the cover itself.
Do this test first: Compare MAP reading to barometric pressure with key on, engine off - they should nearly match
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0106 on the 2011–2014 Volkswagen Jetta — but the community-sourced PCV diaphragm failure (rough idle / P0106) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Valve cover / PCV service: verify — Torque spec for valve-cover bolts not confirmed from a forum source — confirm against factory service info before torquing.
Tips
A torn PCV diaphragm mimics other failures: owners report P0106 (MAP sensor implausible signal), P0507 high idle, P2279 intake leak, rough or hunting idle, and a whistling or honking noise from the valve cover. One 2013 2.5 owner chased what looked like a 09G transmission problem (limp mode, disappearing gear indicator, no codes) that cleared entirely after the diaphragm was replaced.
Volkswagen only sells the official fix as a complete valve cover, but the diaphragm itself is a serviceable round insert. Dorman's 917-064 is a roughly $25 diaphragm-only repair that multiple owners and DIY videos confirm fixes it with basic hand tools.
Quick check: with the engine idling, a failed diaphragm often whistles through its vent hole, and pulling the oil cap or dipstick changes the whistle and the idle. Do not replace the MAP sensor first for P0106 on this engine; check the diaphragm.
If the valve cover itself is oil-soaked or the separator passages are sludged, the diaphragm-only fix may not hold, and then the full cover is the honest repair.
Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light
boost issues
rough running
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failed MAP sensor
Blocked sensor port (carbon/oil sludge)
Wiring fault
Actual mechanical issue (jumped timing gives odd manifold pressure)
Owner notes linked to P0106: 3 across 2 repairs — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 2 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Compare MAP reading to barometric pressure with key on, engine off - they should nearly match Tests: Actual mechanical issue (jumped timing gives odd manifold pressure)
Remove and inspect the sensor port for blockage Tests: Blocked sensor port (carbon/oil sludge)
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2011–2014 Volkswagen Jetta: PCV diaphragm failure (rough idle / P0106) — test first, then buy for this job.
The price range below is a national planning range for P0106 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$30 – $120
Labor$50 – $150
MAP sensor is usually one bolt and a connector. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0106 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →