P0103

P0103: Mass airflow sensor circuit high input

DIY difficulty 1/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The airflow sensor is reporting far more air than is actually entering, so the engine dumps in too much fuel. You'll see black smoke and smell gas; cleaning the sensor often fixes it.

VW/Audi note (VCDS): Compare MAF g/s readings before and after cleaning; a big drop toward normal confirms contamination was the cause.
Model notes: High MAF readings after installing a 'cold air intake' are extremely common - many aftermarket intakes disturb the airflow profile across the sensor and the ECM cannot compensate.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check live data MAF readings at idle and 2500 RPM against expected values Tests: Contaminated or failed MAF sensor reading high (most common)
  2. Clean the sensor and retest
  3. If an aftermarket intake is fitted, temporarily refit the stock airbox to see if readings normalize Tests: Aftermarket high-flow intake or oiled filter skewing readings
  4. Check the signal wire for shorts to voltage if the sensor is new and readings are still high Tests: Contaminated or failed MAF sensor reading high (most common)

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$10 – $250
Labor$50 – $150

Cleaning is cheap; sensor replacement costs more. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0103 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

1 of 5 — Cleaning first, then check for intake modifications before condemning the sensor.

Watch this repair on YouTube

Parts & tools

Intake & throttle toolkit — what the job actually takes

Torque specs: Throttle body bolts: typically 8–12 Nm — verify spec.

Pro tip: Some cars need a throttle relearn after cleaning (scan tool or battery-disconnect procedure), or the idle will hunt.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →