P0106

P0106 on a 2015–2022 Chevrolet Trax: Manifold absolute pressure sensor circuit range/performance

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0106 on a 2017–2024 Chevrolet 2500 · 2015–2022 Chevrolet Trax · 2011–2014 Volkswagen Jetta

DIY difficulty 1/5

The sensor measuring intake manifold pressure is giving implausible readings. Usually a cheap, easy sensor swap.

Model notes: Quick sanity check: with key on and engine off, the MAP reading should nearly match barometric pressure. Also inspect the sensor port for carbon/oil blockage.

Key facts

☑ Before you buy parts — check these first:
On your 2015–2022 Chevrolet Trax (1.4L Turbo LUV) — PCV diaphragm / valve cover failure: Owner-verified
The PCV regulator diaphragm lives under a round cap on the driver side of the valve cover, under the cosmetic engine cover. The whole valve cover comes off with basic hand tools — no timing or manifold work needed.
Do this test first: Compare MAP reading to barometric pressure with key on, engine off - they should nearly match
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0106 on the 2015–2022 Chevrolet Trax — but the community-sourced PCV diaphragm / valve cover failure note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: owner forum · owner forum (1.4T PCV reference) · guide (video, covers Trax) · guide (video, Trax PCV overview)

Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Owner notes linked to P0106: 3 across 2 repairs — these are counts of owner-written notes, not odds of fixing your car.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 2 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Compare MAP reading to barometric pressure with key on, engine off - they should nearly match Tests: Actual mechanical issue (jumped timing gives odd manifold pressure)
  2. Remove and inspect the sensor port for blockage Tests: Blocked sensor port (carbon/oil sludge)

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2015–2022 Chevrolet Trax: PCV diaphragm / valve cover failure — test first, then buy for this job.
The price range below is a national planning range for P0106 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$30 – $120
Labor$50 – $150

MAP sensor is usually one bolt and a connector. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0106 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

1 of 5 — Usually one bolt and a connector.

Watch this repair on YouTube

Parts & tools

Intake & throttle toolkit — what the job actually takes

Torque specs: Throttle body bolts: typically 8–12 Nm — verify spec.

Pro tip: Some cars need a throttle relearn after cleaning (scan tool or battery-disconnect procedure), or the idle will hunt.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →