P0008

P0008 on a 2009–2012 Chevrolet Traverse: Engine position system performance bank 1

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0008 on a 2010–2012 Chevrolet Camaro · 2009–2012 Chevrolet Traverse · 2007–2012 GMC Acadia

DIY difficulty 4/5

Your engine's timing chain has stretched (or a tensioner is failing), so the camshafts on one side of the engine are out of sync with the crankshaft. You'll feel less power and worse mileage, and it only gets worse.

Model notes: Extremely common on GM 3.6L LY7/LLT (Cadillac CTS/SRX, Chevy Traverse, GMC Acadia, Buick Enclave, Saturn Outlook, Suzuki XL7) and 2.8L LP1. Revised parts exist - don't reinstall the old-design chain.

Key facts

☑ Before you buy parts — check these first:
On your 2009–2012 Chevrolet Traverse (3.6L V6 (LLT)) — Timing chain stretch (P0008/P0009 cam-crank correlation): Owner-verified
Front timing-cover teardown on the transverse 3.6L LLT — three chains (one primary, two secondary), tensioners, and guides. Owners report shops pulling the engine or dropping the cradle for access, so this is an advanced-DIY or shop job with a firm quote up front.
Do this test first: Check oil level and condition first - low oil accelerates chain stretch and can mimic timing faults
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0008 on the 2009–2012 Chevrolet Traverse — but the community-sourced Timing chain stretch (P0008/P0009 cam-crank correlation) note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: tech Q&A · tech Q&A · owner repair data · part fitment data

Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).

Typical time: “Owner-reported bills: roughly $1,900-$3,000 for the full chain kit with labor (14.5-16 hours book time).” — as written in the note. First-timers often take twice this.

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Owner notes linked to P0008: 3 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check oil level and condition first - low oil accelerates chain stretch and can mimic timing faults Tests: Stretched timing chain on bank 1 (most common - a known issue on GM 3.6L engines)
  2. Look up technical service bulletins for your engine; some GM 3.6L engines have revised chain kits Tests: Stretched timing chain on bank 1 (most common - a known issue on GM 3.6L engines)
  3. Use live data to watch camshaft-vs-crankshaft correlation on bank 1 at idle and under load Tests: Crankshaft reluctor wheel slipped out of its indexed position
  4. Listen for chain rattle on cold startup, a classic stretched-chain tell Tests: Stretched timing chain on bank 1 (most common - a known issue on GM 3.6L engines)
  5. If correlation is off and the chain is noisy or high-mileage, plan a timing chain, tensioner, and guide replacement
  6. After replacement, verify the crankshaft reluctor wheel is correctly indexed before reassembly

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2009–2012 Chevrolet Traverse: Timing chain stretch (P0008/P0009 cam-crank correlation) — test first, then buy for this job.
The price range below is a national planning range for P0008 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$250 – $700
Labor$800 – $2200

Timing chain, tensioner, and guide replacement (the known fix on affected GM 3.6L engines). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0008 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Diagnosing is easy; fixing means a timing chain job, which is a major teardown on most engines.

Watch this repair on YouTube

Parts & tools

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →