Stop drivingCooling for the power electronics or battery is compromised — driving on can cook expensive parts. Stop and tow.
The electric motor and its power electronics make serious heat and have their own cooling loop with a small electric pump. This code means the computer can't run that pump properly (the part not doing its job the way it should), so the expensive electronics can overheat fast. You can check the coolant level and listen for the pump yourself, but leave any work near the high-voltage parts to a technician.
Key facts
P0A93 means inverter a cooling system performance. The electric motor and its power electronics make serious heat and have their own cooling loop with a small electric pump. This code means the computer can't run that pump properly (the part not doing its job the way it should), so the expensive electronics can overheat fast. You can check the coolant level and listen for the pump yourself, but leave any work near the high-voltage parts to a technician. WrenchFair's published fair-price range for this repair is $200–$1500 parts and $225–$1200 labor at independent shops.
WrenchFair rates P0A93 a 4-of-5 DIY difficulty (“Mostly a shop job: you can check the 12V battery, fuses, and accessible connectors, but high-voltage diagnosis is technician-only.”) with a “Stop driving” driveability rating: Cooling for the power electronics or battery is compromised — driving on can cook expensive parts. Stop and tow. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2010–2015 Lexus RX (3.5L V6 hybrid (2GR-FXE)) — P0A93 'Check Hybrid System' — inverter cooling performance:Owner-verified
Diagnosis is DIY-able (fuse, reservoir flow check, Techstream temps). The inverter coolant pump is replaceable by a competent DIYer with HV precautions (service plug out, insulated gloves, 10-minute capacitor discharge), but inverter assembly replacement is hybrid-shop work.
Do this test first: Start with high-voltage safety: the traction battery and its orange cables carry voltage high enough to kill. Never open the pack or probe HV connectors yourself — DIY on this code means the 12V system, fuses, and accessible low-voltage connectors only.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0A93 on the 2010–2015 Lexus RX — but the community-sourced P0A93 'Check Hybrid System' — inverter cooling performance note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Inverter pump / HV hardware: verify — No DIY torque verified in this run; HV work follows the service manual and factory specs. If you are not HV-comfortable, hand it to a hybrid specialist.
Tips
P0A93 means the hybrid control computer sees the inverter running hotter than the cooling loop can explain. The usual suspects, in order: low inverter coolant, a failed electric inverter water pump, a wiring/connector fault, cooling-fan trouble, or — last — the inverter with converter assembly itself.
Cautionary tale from ClubLexus: a 2010 RX 450h owner paid the dealer to replace the inverter water pump, the P0A93 stayed, and the dealer then quoted $7,000-8,000 for the inverter assembly. Get a real diagnosis before authorizing parts — a pump swap is not a guaranteed fix.
DIY checks before spending: with the car in READY, open the inverter coolant reservoir and look for turbulence — no movement means the pump isn't circulating. Check the INV W/P fuse and the pump connector for corrosion or a pinched harness. A Techstream/compatible scan tool can force-run the pump and read inverter temps.
This loop uses its own coolant and bleed procedure — do not just top up the engine reservoir and call it done. HV safety rules apply: service plug grip out and in your pocket, 10-minute wait, verify 0V.
Typical difficulty: Moderate — based on 294 code guides for the cooling repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
hybrid system warning light on
overheating warning for the hybrid system
reduced power to protect the electronics
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
coolant pump weak
low coolant level
failed electric coolant pump
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Start with high-voltage safety: the traction battery and its orange cables carry voltage high enough to kill. Never open the pack or probe HV connectors yourself — DIY on this code means the 12V system, fuses, and accessible low-voltage connectors only.
Check the coolant level in the power-electronics (inverter) reservoir and look for leaks or pink/white crust around hoses. Tests: low coolant level
Power the car on and listen or feel for the pump running — no vibration with a warming inverter loop means it's not moving coolant. Tests: coolant pump weak
Check the pump's fuse and electrical connector for corrosion.
If coolant was low, bleed air from the loop per the service procedure — trapped air mimics a dead pump.
Pump replacement near HV hardware is best left to a shop.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2010–2015 Lexus RX: P0A93 'Check Hybrid System' — inverter cooling performance — test first, then buy for this job.
The price range below is a national planning range for P0A93 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$200 – $1500
Labor$225 – $1200
coolant pump weak. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0A93 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Mostly a shop job: you can check the 12V battery, fuses, and accessible connectors, but high-voltage diagnosis is technician-only.
Torque specs: Thermostat housing bolts: typically 8–12 Nm. Aluminum threads strip easily — verify spec and use a torque wrench.
Pro tip: Bleed the cooling system per the factory procedure after refilling, or trapped air will overheat the engine and fake a “still broken” reading.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →