P0116/P0117/P0118: Engine coolant temperature sensor circuit range/performance
DIY difficulty 1/5
Diagnose soonCooling system faults can lead to overheating. Watch the temp gauge; stop immediately if it climbs into the red.
The G62 coolant temp sensor signal is out of range. A lying temp sensor causes rich running, bad MPG, and cooling fan confusion.
VW/Audi note (VCDS): A sensor reading -40C or 140C at ambient temp is instantly diagnostic.
Model notes: Cheap part; replace the O-ring and clip with it.
Key facts
P0116/P0117/P0118 means engine coolant temperature sensor circuit range/performance. The G62 coolant temp sensor signal is out of range. A lying temp sensor causes rich running, bad MPG, and cooling fan confusion. WrenchFair's published fair-price range for this repair is $25–$150 parts and $150–$400 labor at independent shops.
WrenchFair rates P0116/P0117/P0118 a 1-of-5 DIY difficulty (“Usually one clip and an O-ring.”) with a “Diagnose soon” driveability rating: Cooling system faults can lead to overheating. Watch the temp gauge; stop immediately if it climbs into the red. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
poor fuel economy
rich running
temp gauge wrong
fans running oddly
low coolant
sweet smell
Likely causes
Failed G62 sensor
Corroded connector (coolant wicks into the plug)
Wiring fault
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 2 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Compare the sensor reading to actual coolant temp with an IR thermometer Tests: Corroded connector (coolant wicks into the plug)
Inspect the connector for green crust - coolant intrusion is common Tests: Corroded connector (coolant wicks into the plug)
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$25 – $150
Labor$150 – $400
Thermostat or sensor is typical; water pump work costs more. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
Torque specs: Thermostat housing bolts: typically 8–12 Nm. Aluminum threads strip easily — verify spec and use a torque wrench.
Pro tip: Bleed the cooling system per the factory procedure after refilling, or trapped air will overheat the engine and fake a “still broken” reading.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →