Diagnose soonSlipping generates heat and wear fast - diagnose promptly, drive gently.
Your transmission is slipping in gear 1 - the computer measured the wrong ratio. Check the fluid level and condition first; low or burnt fluid is the most common cause. If the fluid is fine, it is internal wear.
Key facts
P0731 means gear 1 Incorrect Ratio. Your transmission is slipping in gear 1 - the computer measured the wrong ratio. Check the fluid level and condition first; low or burnt fluid is the most common cause. If the fluid is fine, it is internal wear. WrenchFair's published fair-price range for this repair is $100–$3500 parts and $200–$1500 labor at independent shops.
WrenchFair rates P0731 a 4-of-5 DIY difficulty (“Fluid check first; internal repair needs a transmission shop.”) with a “Diagnose soon” driveability rating: Slipping generates heat and wear fast - diagnose promptly, drive gently. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2020–2022 Ford F-350 (all) — 10R140 harsh engagement / harsh or delayed shifts — TSBs 22-2087, 22-2428 and SSMs:Factory-documented
The TCM reflash and the accelerated main-control break-in routine are dealer scan-tool procedures — document every harsh-shift complaint on the repair order while the 5-year/60,000-mile powertrain warranty is active.
Do this test first: Check the fluid level and condition - burnt smell or dark color is bad news.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0731 on the 2020–2022 Ford F-350 — but the community-sourced 10R140 harsh engagement / harsh or delayed shifts — TSBs 22-2087, 22-2428 and SSMs note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Valve body / internal service: verify — Internal transmission work — dealer or transmission-specialist job; confirm torque in the service manual.
Tips
The 10R140 behind the 6.7L and 7.3L in 2020-2022 F-350s has a stack of Ford bulletins: TSB 22-2087 (harsh reverse-to-drive engagements traced to sticking valves in the main control valve body or suspect input/output shaft seals), TSB 22-2428 (harsh/delayed shift or engagement — PCM/TCM software update), and SSMs 49558/50434 (2021 trucks) prescribing the same 'accelerated main control break-in routine' that cycles solenoids and clutch valves to clear contamination, followed by an adaptive-learning drive cycle.
Ford's own note: most complaints on low-mileage trucks clear up by about 5,000 miles as the valve body breaks in — a slightly clunky brand-new 10-speed is often normal, but persistent harshness is not.
Typical owner pattern on the forums: harsh or delayed engagement that comes and goes, sometimes with transmission DTCs like P0729/P0731 and sometimes with none at all. Get the complaint documented on a dealer repair order early; internal repairs (valve body, seals) are far cheaper under warranty.
Before any internal work, Ford insists on the break-in routine plus the adaptive-learning drive cycle — owners who skipped straight to valve-body replacement sometimes paid for parts they didn't need.
DIY reality: there is no owner-serviceable fix for sticking valve-body valves beyond a proper ULV fluid service at the correct temperature level. Internal transmission work is a specialist job.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
slipping in gear 1
flaring shifts
limp mode
check engine light on
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
low transmission fluid
burnt/contaminated fluid
worn clutch pack 6 owner notes link this repair to P0731
faulty solenoid
valve body fault 6 owner notes link this repair to P0731
Owner notes linked to P0731: 6 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check the fluid level and condition - burnt smell or dark color is bad news. Tests: burnt/contaminated fluid
Scan for all codes and record freeze-frame data, then clear the code and test-drive to see if it returns.
Note which gears slip - one gear points to a clutch pack, all gears to pressure. Tests: worn clutch pack
Have a transmission shop test line pressure if the fluid is good. Tests: low transmission fluid
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2020–2022 Ford F-350: 10R140 harsh engagement / harsh or delayed shifts — TSBs 22-2087, 22-2428 and SSMs — test first, then buy for this job.
The price range below is a national planning range for P0731 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$100 – $3500
Labor$200 – $1500
Fluid service or transmission rebuild per diagnosis. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0731 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Fluid check first; internal repair needs a transmission shop.
Torque specs: Pan bolts: typically 8–12 Nm in a crisscross pattern — verify spec. Over-tightening warps the pan and causes leaks.
Pro tip: Use ONLY the fluid your transmission calls for (e.g. ZF Lifeguard 8 for ZF 8-speeds) — wrong fluid kills transmissions. Measure what came out.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →