Community-sourced DIY repair guides for the 2020–2022 Ford F-350, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Owner-verified repair guides
CP4.2 high-pressure fuel pump failure — recall saga (24V957, then a 2026 re-recall) Factory-documented(6.7L Power Stroke V8 diesel)
Recall work is dealer-only and free; there is no DIY repair. Check your F-350's VIN against recall 24S78 (NHTSA 24V957) and the March 2026 re-recall (Ford 26S17) before assuming you are covered.
Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).
Torque specs
Recall remedy: verify — Dealer PCM software update (24S78/24V957) and re-check under the 2026 re-recall — no DIY torque involved. Verify by VIN.
Tips
NHTSA's recall letter lists FORD/F-350 SD/2020-2022 explicitly: 2020-2022 F-350s with the 6.7L Power Stroke are in the 24V957 population (295,449 trucks total across F-250 through F-750).
Root cause: aged biodiesel deposits forming on the Bosch CP4 pump's drivetrain roller and tappet-body cooling passages — traced to pandemic-era fuel sitting in tanks too long. Ford had 3,070 warranty reports and no known crashes when it filed the recall in December 2024.
Warning signs owners should act on: extended cranking before start, a louder-than-normal fuel pump, reduced power, and the check-engine light. A failed pump can strand the truck and scatter metal through the fuel system (a $10,000+ repair out of warranty).
The recall remedy is a PCM software update (increased pump cooling to prevent deposit formation) done free at the dealer — not a new pump — though pumps already failing get replaced under warranty.
March 2026 twist: Ford issued a second campaign (Ford ref 26S17, ~7,105 trucks) for 2020-2022 Super Duty trucks, F-350s included, that were repaired INCORRECTLY under 24V957. If your F-350 already had the 24V957 work done, re-check the VIN — you may be in the re-recall.
Buyers of used 2020-2022 F-350 6.7Ls: confirm BOTH recall campaigns show completed for the VIN, and budget for a CP4 disaster-prevention kit or DCR conversion if the truck is out of warranty and you plan to keep it.
10R140 harsh engagement / harsh or delayed shifts — TSBs 22-2087, 22-2428 and SSMs Factory-documented(all)
The TCM reflash and the accelerated main-control break-in routine are dealer scan-tool procedures — document every harsh-shift complaint on the repair order while the 5-year/60,000-mile powertrain warranty is active.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
Torque specs
Valve body / internal service: verify — Internal transmission work — dealer or transmission-specialist job; confirm torque in the service manual.
Tips
The 10R140 behind the 6.7L and 7.3L in 2020-2022 F-350s has a stack of Ford bulletins: TSB 22-2087 (harsh reverse-to-drive engagements traced to sticking valves in the main control valve body or suspect input/output shaft seals), TSB 22-2428 (harsh/delayed shift or engagement — PCM/TCM software update), and SSMs 49558/50434 (2021 trucks) prescribing the same 'accelerated main control break-in routine' that cycles solenoids and clutch valves to clear contamination, followed by an adaptive-learning drive cycle.
Ford's own note: most complaints on low-mileage trucks clear up by about 5,000 miles as the valve body breaks in — a slightly clunky brand-new 10-speed is often normal, but persistent harshness is not.
Typical owner pattern on the forums: harsh or delayed engagement that comes and goes, sometimes with transmission DTCs like P0729/P0731 and sometimes with none at all. Get the complaint documented on a dealer repair order early; internal repairs (valve body, seals) are far cheaper under warranty.
Before any internal work, Ford insists on the break-in routine plus the adaptive-learning drive cycle — owners who skipped straight to valve-body replacement sometimes paid for parts they didn't need.
DIY reality: there is no owner-serviceable fix for sticking valve-body valves beyond a proper ULV fluid service at the correct temperature level. Internal transmission work is a specialist job.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
We don't have factory bulletin data for the 2020–2022 Ford F-350 yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.