Diagnose soonIf the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter.
The ignition coil for cylinder 1 has an electrical fault.
Key facts
P0351 means ignition coil 'A' primary/secondary circuit. The ignition coil for cylinder 1 has an electrical fault. WrenchFair's published fair-price range for this repair is $40–$150 parts and $50–$150 labor at independent shops.
WrenchFair rates P0351 a 2-of-5 DIY difficulty (“Swap the coil with another cylinder - if the code follows, the coil is bad.”) with a “Diagnose soon” driveability rating: If the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 928 factory bulletins on file for this vehicle (mostly Electrical System, Equipment, Engine And Engine Cooling) — see the latest ones
On your 2012–2018 BMW 3 Series (N20 2.0L turbo I4, N26 2.0L turbo I4) — Spark plugs and ignition coils:Owner-verified
Lift off the engine cover, then remove the strut tower brace (E18 bolts) and the cowl/lower trim pieces plus the noise-insulation pad over the valve cover to expose the coil wells. Lift the lock on each ignition coil, disconnect the harness, and pull the coil out of the spark plug tube. Use a thin-wall BMW spark plug socket (the N20 also needs the narrow 14mm socket) with extensions to remove the plugs, thread the new plugs in by hand, torque to 23 Nm, then push the new coils down until they bottom out, reconnect the harness and lock it. Refit the cowl, brace, and cover.
Do this test first: Swap coil A with another cylinder's coil
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0351 on the 2012–2018 BMW 3 Series — but the community-sourced Spark plugs and ignition coils note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Spark plugs to cylinder head (N20/N26): 23 Nm — Per the FCP Euro F30 N20/N26 ignition service guide.
Strut tower brace bolts (reinstall): 56 Nm + 90° — Per the FCP Euro F30 N20/N26 guide; drive in with an E18 socket.
Tips
Coils are push-fit with a locking harness connector — there are no coil hold-down bolts to torque.
Thread plugs in by hand first, then finish with a torque wrench; never drop a plug into the well (it can close the electrode gap).
Do not grease or oil the plug threads (ISTA/BMW procedure forbids it).
Spark plugs/coils need no coding or registration — they are on the 'does not require coding' list for F-series cars.
Typical difficulty: Easy — based on 64 code guides for the ignition repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light (may flash)
misfire on cylinder 1
rough idle
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failed ignition coil A (most common) 11 owner notes link this repair to P0351
Damaged wiring or corroded connector
Failed coil driver in the ECM
Owner notes linked to P0351: 11 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Swap coil A with another cylinder's coil
Check the coil connector for corrosion Tests: Damaged wiring or corroded connector
Test coil power and ground
Replace the coil if the fault follows it
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2012–2018 BMW 3 Series: Spark plugs and ignition coils — test first, then buy for this job.
Expensive fork: Fuel injector, then compression test — if the misfire stays on the same cylinder after a fresh plug and a swapped coil.
The price range below is a national planning range for P0351 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$40 – $150
Labor$50 – $150
Ignition coil replacement (coil A). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0351 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Swap the coil with another cylinder - if the code follows, the coil is bad.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →