Diagnose soonIf the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter.
Can I drive with P0305?
Can I drive with a P0305 code?
Short trips and gentle driving only, until you know the cause. If the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter. If the check-engine light starts flashing, the engine shakes badly, or the car loses significant power, pull over safely and have it towed.
How serious is P0305?
Moderate. WrenchFair rates this one “Diagnose soon” — the car can usually get you home, but driving on it can turn a cheap fix into an expensive one. If the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter.
Will P0305 go away on its own?
The warning light can turn off by itself after clean drive cycles, but the code stays stored in the computer's memory and the fault is still there. Clearing it without fixing the cause just buys time — it will come back when the computer re-runs the self-test. Exception: a loose gas cap — tighten it and drive a few days.
Cylinder 5 is misfiring - a bad coil, worn plug, or weak injector is the usual cause. A flashing check engine light means stop driving.
Key facts
P0305 means cylinder 5 misfire detected. Cylinder 5 is misfiring - a bad coil, worn plug, or weak injector is the usual cause. A flashing check engine light means stop driving. WrenchFair's published fair-price range for this repair is $40–$150 parts and $50–$150 labor at independent shops.
WrenchFair rates P0305 a 2-of-5 DIY difficulty (“Swap the coil with another cylinder first.”) with a “Diagnose soon” driveability rating: If the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2009–2018 Ram 1500 (5.7L HEMI V8) — 5.7 Hemi cam/lifter failure: MDS lifter collapse:Owner-verified
Full diagnosis (coil/plug/injector swap, compression test) is all under-hood, no teardown. The repair itself is heads-off engine work: intake off, heads pulled, cam out the front. Plan a full weekend and a parts list before you start.
Do this test first: Swap the cylinder 5 coil with another cylinder
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0305 on the 2009–2018 Ram 1500 — but the community-sourced 5.7 Hemi cam/lifter failure: MDS lifter collapse note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Rocker arm / valvetrain hardware: verify — Heads-off cam/lifter job - torque every valvetrain fastener and the cam bolt per factory service info; owner parts lists don't publish torque specs.
Tips
The signature start is a single-cylinder misfire (often P0305) that a tick which never fades joins. The 2011 thread's owner: cylinder 5 misfire, ruled out plugs/coil/injector/wiring, compression 200 psi on the bad cylinder (5% of a healthy neighbor - so it CAN'T be top-end sealing), which left the cam/lifter as the only suspect. That's the diagnostic chain to copy.
Rule out the cheap stuff first: swap coil and plug to another cylinder and see if the misfire moves. If the misfire stays on the same cylinder with good compression, you're likely looking at a collapsed MDS lifter eating the cam lobe - owners find the lobe visibly worn (cylinders 2, 5, 8 reported) once the cam comes out.
While you're in there, budget the full job like the owners do: cam, all lifters, all 4 MDS solenoids, VVT solenoid, timing chain + VVT phaser, oil pump (Melling high-volume is the community favorite), water pump, plugs, coils, and check the heads. One owner landed at ~$3,500 in genuine parts for the whole job and another at ~$1,800 doing the top end himself over a couple of weekends.
MDS lifters are the usual victim, but owners report non-MDS Hemis failing the same way - the community's blame list is poor lifter needle-bearing quality plus lubrication failure from extended idling, not just the MDS design. Don't let a non-MDS truck talk you out of checking.
The owner consensus on prevention: 5,000-mile oil changes, quality oil and filter, and don't let the truck sit idling for long stretches. It doesn't hit every truck - but it's common enough on the 4th gen that a 2011 owner planned his whole rebuild budget around it.
Verify part numbers and torque specs against factory service info before ordering - Mopar front lifters have gone through supersessions and owners report availability quirks. Replace the MDS solenoids while the lifters are out; they're cheap insurance on a teardown this deep.
Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light (may flash)
rough idle
hesitation
loss of power
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failed ignition coil on cylinder 5 (most common) 11 owner notes link this repair to P0305
Worn or fouled spark plug 11 owner notes link this repair to P0305
Clogged fuel injector
Low compression on cylinder 5
Owner notes linked to P0305: 15 across 3 repairs — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Swap the cylinder 5 coil with another cylinder Tests: Failed ignition coil on cylinder 5 (most common)
Inspect the spark plug Tests: Worn or fouled spark plug
Check compression on cylinder 5 Tests: Low compression on cylinder 5
Test the fuel injector Tests: Clogged fuel injector
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2009–2018 Ram 1500: 5.7 Hemi cam/lifter failure: MDS lifter collapse — test first, then buy for this job.
Expensive fork: Fuel injector, then compression test — if the misfire stays on the same cylinder after swapping the coil and plug — not a second set of coils.
The price range below is a national planning range for P0305 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$40 – $150
Labor$50 – $150
Ignition coil and spark plug replacement (cylinder 5). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0305 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Swap the coil with another cylinder first.
🔌 Read your spark plugs This code names the unhappy system; your plugs show what the combustion actually looks like. Pull one and match it to the visual chart — how to read your spark plugs →
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →