Diagnose soonFuel starvation causes power loss under load and can strand you. Diagnose soon.
The fuel pressure sensor works but its readings don't make sense - it's drifting with age. The computer can't regulate fuel pressure accurately.
Model notes: This code sets false-positive sensor replacements constantly - the sensor is often the messenger reporting a genuinely weak pump. The gauge comparison prevents the mistake.
Key facts
P0191 means fuel rail pressure sensor circuit range/performance. The fuel pressure sensor works but its readings don't make sense - it's drifting with age. The computer can't regulate fuel pressure accurately. WrenchFair's published fair-price range for this repair is $30–$500 parts and $150–$500 labor at independent shops.
WrenchFair rates P0191 a 3-of-5 DIY difficulty (“The critical step is determining whether the sensor is lying or telling the truth about a real pressure problem.”) with a “Diagnose soon” driveability rating: Fuel starvation causes power loss under load and can strand you. Diagnose soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 454 factory bulletins on file for this vehicle (mostly Electrical System, Equipment, Engine And Engine Cooling) — see the latest ones
On your 2017–2022 Honda CR-V (1.5L turbo (L15BE)) — Fuel pump replacement:Owner-verified
No tank drop needed: fold the left side rear seat forward and pull back the carpet to expose the fuel tank unit access panel in the floor (per the factory manual). Relieve fuel pressure first per Honda's procedure — disable the pump, then disconnect the fuel tube/quick-connect fitting in the engine compartment — and disconnect the battery. The pump module comes out through the panel; the recall TSB procedure specifies a new O-ring (do not coat it with oil), aligning the tank-unit tab, installing the cam lock ring by hand, then tightening it clockwise with a fuel sender wrench and confirming the ring is not 'floating.' After reassembly, cycle the ignition ON (engine off) two to three times to prime the lines and check for leaks. Note: the 1.5T also has a cam-driven high-pressure pump on the engine — this job is the in-tank module only.
Do this test first: Compare the sensor PID against a mechanical gauge - this single test decides the whole direction
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0191 on the 2017–2022 Honda CR-V — but the community-sourced Fuel pump replacement note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Fuel tank unit cam lock ring: verify — Confirm against factory service info before torquing.
Tips
Check the fuel pump impeller recall first: 2018-2020 CR-Vs are covered by NHTSA 23V-858 (Honda KGC/KGD), an expansion of 21V-215/20V-314 — dealers replace the pump module free; check your VIN on NHTSA or Honda's recall site before buying parts.
Pump runs for ~2 seconds at key-on (listen at the filler neck with the cap off) — a quick no-start diagnosis straight from the factory troubleshooting tree.
Use a new O-ring and cam lock ring; do not oil the O-ring, and seat the lock ring tabs into the positioning edge by hand before tightening so it doesn't float.
Do not bend the fuel level sensor arm during removal — it can cause inaccurate gauge readings.
Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light
hesitation
poor performance under load
possible lean or rich symptoms
engine cranks but won't start
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Drifting fuel pressure sensor (most common)
Actual fuel pressure problem the sensor is correctly reporting - verify before replacing
Weak fuel pump causing pressure the sensor faithfully reports as wrong
Clogged fuel filter restricting flow
Owner notes linked to P0191: 5 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Compare the sensor PID against a mechanical gauge - this single test decides the whole direction
If the gauge agrees with the sensor, diagnose the fuel delivery problem (pump, filter, regulator) Tests: Actual fuel pressure problem the sensor is correctly reporting - verify before replacing
If the gauge disagrees, replace the sensor
Always replace the fuel filter before condemning a pump on high-mileage vehicles Tests: Actual fuel pressure problem the sensor is correctly reporting - verify before replacing
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2017–2022 Honda CR-V: Fuel pump replacement — test first, then buy for this job.
The price range below is a national planning range for P0191 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$30 – $500
Labor$150 – $500
Filter is cheap; fuel pump replacement is moderate to expensive. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0191 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — The critical step is determining whether the sensor is lying or telling the truth about a real pressure problem.
Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →