P0191

P0191 on a 2014–2019 Chevrolet Silverado 1500: Fuel rail pressure sensor circuit range/performance

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0191 on a 2014–2019 Chevrolet Silverado 1500 · 2018–2022 Honda Accord · 2017–2022 Honda CR-V · 2018–2024 Toyota Camry · 2019–2026 Toyota Corolla

DIY difficulty 3/5

The fuel pressure sensor works but its readings don't make sense - it's drifting with age. The computer can't regulate fuel pressure accurately.

Model notes: This code sets false-positive sensor replacements constantly - the sensor is often the messenger reporting a genuinely weak pump. The gauge comparison prevents the mistake.

Key facts

☑ Before you buy parts — check these first:
On your 2014–2019 Chevrolet Silverado 1500 (5.3L V8) — Fuel pump replacement: Owner-verified
There is no factory access panel on K2XX Silverados, so owners either unbolt and lift or shift the bed aside, or drop the tank with a floor jack (the 2015 5.3L walkthrough drops the tank using ramps, jack stands, and 10/13/15/8mm sockets). Either way, disconnect the battery, relieve fuel pressure, and disconnect the filler neck, EVAP lines, and the pump's electrical connector before lowering anything. The in-tank module is spring-loaded and held by a locking ring, turned with a brass punch and hammer or a lock-ring tool; on 2014+ trucks the pressure regulator is built into the pump module itself. New modules come with a fresh tank gasket, and silveradosierra owners recommend replacing the locking ring at the same time.
Do this test first: Compare the sensor PID against a mechanical gauge - this single test decides the whole direction
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0191 on the 2014–2019 Chevrolet Silverado 1500 — but the community-sourced Fuel pump replacement note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: 1A Auto: How to Replace Fuel Pump Assembly 2014-2018 Chevrolet Silverado 1500 (2015 5.3L walkthrough) · 2017 Chevy Silverado fuel pump replacement DIY walkthrough · silveradosierra.com: Fuel Pump Failing? (bed lift vs tank drop, locking ring, Haynes pressure specs)

Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).

Typical time: “Budget 2-3 hours and basic hand tools; the 2017 Silverado walkthrough rates this an intermediate-difficulty job.” — as written in the note. First-timers often take twice this.

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Owner notes linked to P0191: 5 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Compare the sensor PID against a mechanical gauge - this single test decides the whole direction
  2. If the gauge agrees with the sensor, diagnose the fuel delivery problem (pump, filter, regulator) Tests: Actual fuel pressure problem the sensor is correctly reporting - verify before replacing
  3. If the gauge disagrees, replace the sensor
  4. Always replace the fuel filter before condemning a pump on high-mileage vehicles Tests: Actual fuel pressure problem the sensor is correctly reporting - verify before replacing

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2014–2019 Chevrolet Silverado 1500: Fuel pump replacement — test first, then buy for this job.
The price range below is a national planning range for P0191 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$30 – $500
Labor$150 – $500

Filter is cheap; fuel pump replacement is moderate to expensive. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0191 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — The critical step is determining whether the sensor is lying or telling the truth about a real pressure problem.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →