Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonFuel starvation causes power loss under load and can strand you. Diagnose soon.
The fuel pressure sensor is reading near zero, so the computer thinks there's almost no fuel pressure. The car may go into reduced power or struggle to start.
VW/Audi note (VCDS): The engine running normally with a near-zero pressure PID is the giveaway of a sensor or wiring fault rather than a real pressure loss.
Model notes: A sensor reading zero pressure while the engine runs fine is obviously lying - but verify with the gauge anyway, because a failing pump can read low and still barely run the engine.
Key facts
P0192 means fuel rail pressure sensor circuit low input. The fuel pressure sensor is reading near zero, so the computer thinks there's almost no fuel pressure. The car may go into reduced power or struggle to start. WrenchFair's published fair-price range for this repair is $30–$500 parts and $150–$500 labor at independent shops.
WrenchFair rates P0192 a 3-of-5 DIY difficulty (“Distinguish wiring/sensor faults from genuinely low pressure with a mechanical gauge.”) with a “Diagnose soon” driveability rating: Fuel starvation causes power loss under load and can strand you. Diagnose soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
hard starting or no-start
reduced power
check engine light
fuel pump running constantly at full speed
Likely causes
Signal wire shorted to ground or open (most common)
Failed sensor with internal short
Actually low fuel pressure from a failed pump - verify
Corroded connector
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check actual pressure with a mechanical gauge first - if pressure is truly low, diagnose the pump and filter Tests: Actually low fuel pressure from a failed pump - verify
If the gauge reads normal, unplug the sensor: if the PID stays pinned low, the wiring is shorted to ground Tests: Signal wire shorted to ground or open (most common)
Verify 5V reference and ground at the connector Tests: Corroded connector
Replace the sensor if wiring is good
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$30 – $500
Labor$150 – $500
Filter is cheap; fuel pump replacement is moderate to expensive. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0192 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Distinguish wiring/sensor faults from genuinely low pressure with a mechanical gauge.
Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →