Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonLean running under load can damage the engine - diagnose soon and drive gently.
Your second airflow sensor is reading too low - it's dirty, unplugged, or has a wiring fault. The engine may run lean.
Key facts
P010C means mAF sensor 'B' circuit low. Your second airflow sensor is reading too low - it's dirty, unplugged, or has a wiring fault. The engine may run lean. WrenchFair's published fair-price range for this repair is $60–$250 parts and $80–$200 labor at independent shops.
WrenchFair rates P010C a 2-of-5 DIY difficulty (“Check the connector first, then clean the sensor.”) with a “Diagnose soon” driveability rating: Lean running under load can damage the engine - diagnose soon and drive gently. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
lean running
hesitation
possible misfires
Likely causes
Contaminated 'B' MAF sensor (most common)
Unplugged 'B' MAF connector
Wiring fault pulling the signal low
Failed 'B' MAF sensor
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Verify the 'B' MAF connector is fully seated Tests: Unplugged 'B' MAF connector
Clean the sensor with dedicated cleaner
Compare 'A' and 'B' readings
Check the wiring for faults Tests: Wiring fault pulling the signal low
Replace the 'B' sensor if it reads low when clean and connected
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$60 – $250
Labor$80 – $200
MAF sensor 'B' cleaning or replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P010C ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Check the connector first, then clean the sensor.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →