P0107

P0107: Manifold absolute pressure sensor circuit low input

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The manifold pressure sensor is reading impossibly low, tricking the computer into thinking the engine is always idling. It starves the engine of fuel when you accelerate, causing hesitation.

VW/Audi note (VCDS): The unplug test separates sensor faults from wiring faults in seconds on MAP circuits.
Model notes: A MAP sensor stuck reading high vacuum makes the ECM think the engine is always at light load - the resulting lean condition under acceleration is the classic symptom.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check KOEO reading - near zero or implausibly low confirms the fault Tests: Failed MAP sensor reading low (most common)
  2. Unplug the sensor: if the reading jumps to the high/default value, the sensor is bad; if it stays low, the wiring is shorted to ground Tests: Failed MAP sensor reading low (most common)
  3. Clean the manifold port Tests: Clogged MAP port reading manifold vacuum incorrectly
  4. Verify reference voltage and ground

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$10 – $250
Labor$50 – $150

Cleaning is cheap; sensor replacement costs more. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0107 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Low input usually means open circuit or dead sensor - quick to confirm with KOEO readings.

Watch this repair on YouTube

Parts & tools

Intake & throttle toolkit — what the job actually takes

Torque specs: Throttle body bolts: typically 8–12 Nm — verify spec.

Pro tip: Some cars need a throttle relearn after cleaning (scan tool or battery-disconnect procedure), or the idle will hunt.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →