Diagnose soonThe affected feature may quit without warning — inconvenient, and occasionally a visibility or security issue.
Your car has a dozen-plus small computers that constantly share data. The body computer (lights, locks, wipers) is sending messages that don't make sense — impossible numbers, frozen values, or garbled frames — so the other computers are ignoring it. Whatever that part controls may act up or quit without warning.
Key facts
U0422 means invalid Data Received From Body Control Module. Your car has a dozen-plus small computers that constantly share data. The body computer (lights, locks, wipers) is sending messages that don't make sense — impossible numbers, frozen values, or garbled frames — so the other computers are ignoring it. Whatever that part controls may act up or quit without warning. WrenchFair's published fair-price range for this repair is $150–$600 parts and $120–$300 labor at independent shops.
WrenchFair rates U0422 a 2-of-5 DIY difficulty (“Checking the battery, connectors, and wiring is solid DIY work; condemning or replacing the module itself usually isn't.”) with a “Diagnose soon” driveability rating: The affected feature may quit without warning — inconvenient, and occasionally a visibility or security issue. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2022–2024 Jeep Wagoneer — 12V battery drain / dead after sitting:Owner-verified
Most fixes are dealer software flashes (wiTECH), but the owner-side work is diagnosis: identify which module is staying awake before authorizing parts.
Do this test first: Test the battery and charging system first — low or unstable voltage is the most common cause of garbage data on the network.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for U0422 on the 2022–2024 Jeep Wagoneer — but the community-sourced 12V battery drain / dead after sitting note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Battery terminals: verify — No torque-critical fasteners in the drain diagnosis itself; confirm battery terminal torque against factory service info if the battery is replaced.
Tips
Early 2022 trucks had an amplifier drain problem covered by a recall: owners report the truck dead after sitting, needing jump starts multiple times in the first month. One owner confirmed the dealer fixed it with a software flash plus a new battery and had no further issues with the drain.
For 2022-2024 trucks, TSB 08-017-24 targets the Telematics Box Module (TBM2): a software glitch keeps it awake searching for a signal after shutdown, killing the battery in 24-48 hours. Symptoms include remote-start and proximity-entry failures. The fix is a dealer flash to software version 23.36 or higher.
Two more documented drain paths: the Power Side Step Module (TSB 0809922REVC, DTC U0422 - the module can fail to enter sleep and drain the battery) and the Power Liftgate Module (TSB 0805923 - battery drain after the liftgate closes following an opening obstruction; fixed by reprogramming the PLGM).
Do not just keep replacing the battery: TSB 08-216-23 requires dealers to perform ignition-off-draw (IOD) testing to root-cause the drain before swapping batteries, looking for draw above roughly 30 mA after the truck sleeps. Insist on this test - repeated deep discharges permanently damage the battery, so also demand a load test.
Owner-side triage: remove aftermarket electronics and anything plugged into the OBD port before diagnosis (the TSB calls these out as drain sources), and note whether the drain started after a liftgate obstruction event or a software update - that points at the PLGM or TBM2 respectively.
Typical difficulty: Moderate — based on 1374 code guides for the electrical repair area (an area-level estimate, not this exact job).
Typical time: “For 2022-2024 trucks, TSB 08-017-24 targets the Telematics Box Module (TBM2): a software glitch keeps it awake searching for a signal after shutdown, killing the battery in 24-48 hours.” — as written in the note. First-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
affected feature works only sometimes
warning messages on the dash
other modules log the same code
related functions stop responding
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
weak battery or failing alternator corrupting network data 2 owner notes link this repair to U0422
corroded or loose connector at the body computer (lights, locks, wipers) 2 owner notes link this repair to U0422
damaged wiring or poor ground to the body computer (lights, locks, wipers) 2 owner notes link this repair to U0422
a sensor feeding the body computer (lights, locks, wipers) reporting bad values 2 owner notes link this repair to U0422
software/calibration mismatch after a repair 2 owner notes link this repair to U0422
internal fault in the body computer (lights, locks, wipers) 2 owner notes link this repair to U0422
Owner notes linked to U0422: 2 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Test the battery and charging system first — low or unstable voltage is the most common cause of garbage data on the network. Tests: weak battery or failing alternator corrupting network data
Scan every module on the vehicle and record all codes; pay special attention to any faults the body computer (lights, locks, wipers) reports about itself or its own sensors. Tests: a sensor feeding the body computer (lights, locks, wipers) reporting bad values
Inspect the body computer (lights, locks, wipers)'s connector and wiring for corrosion, loose or pushed-back pins, water intrusion, or rodent damage, and verify its power and ground feeds. Tests: corroded or loose connector at the body computer (lights, locks, wipers)
Clear all codes, drive normally, and rescan — if this code returns together with the body computer (lights, locks, wipers)'s own sensor or input codes, fix those inputs first, since bad data in means bad data out. Tests: a sensor feeding the body computer (lights, locks, wipers) reporting bad values
If power, ground, and wiring all test good and the body computer (lights, locks, wipers) keeps broadcasting implausible values, the module itself is suspect — replacement or reprogramming is usually a dealer or specialist job.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2022–2024 Jeep Wagoneer: 12V battery drain / dead after sitting — test first, then buy for this job.
The price range below is a national planning range for U0422 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$150 – $600
Labor$120 – $300
Repairing the wiring or connector at the body computer (lights, locks, wipers), or replacing the module. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for U0422 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Checking the battery, connectors, and wiring is solid DIY work; condemning or replacing the module itself usually isn't.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →