Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonNetwork communication fault. May cause unpredictable behavior.
Can I drive with P0600?
Can I drive with a P0600 code?
Short trips and gentle driving only, until you know the cause. Network communication fault. May cause unpredictable behavior. If the check-engine light starts flashing, the engine shakes badly, or the car loses significant power, pull over safely and have it towed.
How serious is P0600?
Moderate. WrenchFair rates this one “Diagnose soon” — the car can usually get you home, but driving on it can turn a cheap fix into an expensive one. Network communication fault. May cause unpredictable behavior.
Will P0600 go away on its own?
The warning light can turn off by itself after clean drive cycles, but the code stays stored in the computer's memory and the fault is still there. Clearing it without fixing the cause just buys time — it will come back when the computer re-runs the self-test. Exception: a loose gas cap — tighten it and drive a few days.
The communication network connecting your car's computers has a fault. Expect weird, seemingly unrelated symptoms - warning lights, dead gauges, things not talking to each other.
VW/Audi note (VCDS): A full module scan showing exactly which modules answer and which don't is the roadmap for the whole diagnosis.
Model notes: One bad module can silence the whole network - the unplug-one-at-a-time method finds it reliably. Aftermarket electronics (alarms, remote starts) spliced into the bus are frequent culprits.
Key facts
P0600 means serial communication link malfunction. The communication network connecting your car's computers has a fault. Expect weird, seemingly unrelated symptoms - warning lights, dead gauges, things not talking to each other. WrenchFair's published fair-price range for this repair is $100–$400 parts and $150–$400 labor at independent shops.
WrenchFair rates P0600 a 4-of-5 DIY difficulty (“Network diagnosis needs a wiring diagram and patience; the unplug-one-module method is the key technique.”) with a “Diagnose soon” driveability rating: Network communication fault. May cause unpredictable behavior. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
multiple warning lights
dead gauges
modules not communicating
no-start on severe faults
check engine light
sudden drop in fuel mileage
rough running with weak acceleration
Likely causes
Corroded or damaged CAN bus wiring (most common)
Failed module dragging the bus down
Water intrusion in a module or connector
Poor ground shared by modules
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Scan all modules and note which ones don't respond - the silent ones are suspects
Check CAN bus resistance (should be ~60 ohms across the bus with battery disconnected)
Unplug modules one at a time - when communication restores, the last unplugged module is the culprit
Inspect wiring where the harness flexes (doors, trunk hinges) and for water intrusion Tests: Water intrusion in a module or connector
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$100 – $400
Labor$150 – $400
Wiring or module diagnosis; costs vary widely. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0600 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Network diagnosis needs a wiring diagram and patience; the unplug-one-module method is the key technique.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →