U0109

U0109 on a 2007–2014 Chevrolet Tahoe: Lost communication with Fuel pump control module

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: U0109 on a 2007–2014 Chevrolet Tahoe

DIY difficulty 2/5

Your car's computers all chat over a shared wiring network. Right now, the fuel pump control module — the part that handles fuel delivery — has stopped answering. The engine may not start or may stall. Check the simple stuff first: a blown fuse or a loose, corroded connector is a far more common cause than a dead module.

Key facts

☑ Before you buy parts — check these first:
On your 2007–2014 Chevrolet Tahoe (5.3L V8, 6.2L V8) — Fuel pump control module water intrusion (stall): Owner-verified
The fuel pump control module sits underneath the truck near the spare tire, exposed to road spray. It is a sealed plastic box with an RTV gasket — when that seal separates, water gets inside. The module is secured with bolts that are often heavily rusted.
Do this test first: Read all codes with a scan tool. This code is set by a listening module, not the silent one — note any companion codes naming other offline modules or bus faults, which point at shared power or wiring instead of one bad module.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for U0109 on the 2007–2014 Chevrolet Tahoe — but the community-sourced Fuel pump control module water intrusion (stall) note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: owner forum (solved case) · owner forum (U0109 thread)

Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Read all codes with a scan tool. This code is set by a listening module, not the silent one — note any companion codes naming other offline modules or bus faults, which point at shared power or wiring instead of one bad module. Tests: The fuel pump control module failed internally (possible but uncommon — rule out power…
  2. Check the fuses for the fuel pump control module using the owner's manual fuse chart. A blown, corroded, or loose fuse is the cheapest possible cause — don't skip this step. Tests: Blown fuse or corroded fuse holder feeding the fuel pump control module (most common easy…
  3. Unplug the connector at the fuel pump control module and verify its power and ground with a multimeter. Look closely for green corrosion, backed-out pins, or water inside the connector — most 'dead module' diagnoses turn out to be bad connections. Tests: Loose, corroded, or water-damaged connector at the fuel pump control module
  4. Trace the data-bus wiring to the fuel pump control module: look for chafed or pinched harness runs, water intrusion at connectors, and aftermarket devices (alarms, remote starters, trackers) tapped into the bus. Tests: Chafed, pinched, or broken data-bus wiring running to the fuel pump control module
  5. If power, ground, and wiring all check out, the module itself may have failed — but replacement modules usually need programming to the vehicle, so confirm the wiring first and get a second opinion before buying one.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2007–2014 Chevrolet Tahoe: Fuel pump control module water intrusion (stall) — test first, then buy for this job.
The price range below is a national planning range for U0109 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$0 – $600
Labor$120 – $300

Blown fuse or wiring repair (most common). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for U0109 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Finding a blown fuse or bad connector is easy; tracing bus wiring to the module is the part that takes patience.

Watch this repair on YouTube

Parts & tools

Electrical diagnosis toolkit — what the job actually takes

Torque specs: Module connectors: hand-tight until they click — never force them.

Pro tip: Check powers AND grounds before condemning a module — most “module failures” are wiring. Disconnect the battery before unplugging modules.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →