P2D89: Fan 1 Control Module Supply Voltage Circuit
DIY difficulty 3/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonNo fan means overheating in traffic - watch the gauge closely and fix it before hot weather or a traffic jam.
The control module built into your cooling fan 1 is reporting a fault. The fan may not run when the engine needs it - watch the temperature gauge.
Key facts
P2D89 means fan 1 Control Module Supply Voltage Circuit. The control module built into your cooling fan 1 is reporting a fault. The fan may not run when the engine needs it - watch the temperature gauge. WrenchFair's published fair-price range for this repair is $150–$500 parts and $150–$350 labor at independent shops.
WrenchFair rates P2D89 a 3-of-5 DIY difficulty (“Fan swaps are usually a shroud and a few bolts, but some cars bury the fan behind the bumper.”) with a “Diagnose soon” driveability rating: No fan means overheating in traffic - watch the gauge closely and fix it before hot weather or a traffic jam. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
engine temperature climbing in traffic
fan not running when it should
a/c blowing warm at idle
check engine light on
Likely causes
Failed fan control module (most common)
Seized or worn fan motor overloading the module
Heat-damaged connector or poor power/ground feed
Blown fan fuse
module supply fuse blown
wiring or connector fault
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Read the code and check whether the fan runs when commanded - use the scan tool's output test.
Check the fan's fuses and the main power and ground feeds at the fan connector. Tests: Heat-damaged connector or poor power/ground feed
Inspect the fan connector for heat damage or corrosion - high current melts marginal connections. Tests: Heat-damaged connector or poor power/ground feed
If power and ground are good but the fan will not run or reports a fault, replace the fan assembly. Tests: Heat-damaged connector or poor power/ground feed
Verify the new fan responds to commands across its speed range.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$150 – $500
Labor$150 – $350
Cooling fan assembly replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2D89 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Fan swaps are usually a shroud and a few bolts, but some cars bury the fan behind the bumper.
Torque specs: Thermostat housing bolts: typically 8–12 Nm. Aluminum threads strip easily — verify spec and use a torque wrench.
Pro tip: Bleed the cooling system per the factory procedure after refilling, or trapped air will overheat the engine and fake a “still broken” reading.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →