P2B23

P2B23: Hybrid/EV Electronics Coolant Temperature Sensor B Circuit High

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Your hybrid/EV cools its power electronics with liquid, and the temperature sensor watching that loop is giving a bad reading. The car will limit power to protect the electronics. Usually the sensor or its wiring.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Do not open, probe, or service the high-voltage system yourself - it carries lethal voltage. Diagnose only up to the low-voltage control side; anything involving the pack, contactors, inverter, or orange HV cabling is qualified-technician work.
  2. Read the code with a scan tool and save the freeze-frame data, then check for companion codes - when several sensor codes appear together, suspect a shared reference-voltage or ground problem before any single sensor.
  3. Check the electronics coolant level first - low coolant makes sensors lie. Tests: Low coolant or air in the electronics loop skewing the reading (check the level first)
  4. Inspect the sensor B wiring and connector. Tests: Damaged wiring or corroded connector
  5. Compare the reading against a plausible value per the service manual.
  6. Replace the sensor if it reads wrong, bleed the loop, clear the code, and confirm normal readings.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$60 – $200
Labor$120 – $300

Hybrid/EV coolant temperature sensor B replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2B23 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — High-voltage safety first, then it is sensor testing and replacement.

Watch this repair on YouTube

Parts & tools

Cooling system toolkit — what the job actually takes

Torque specs: Thermostat housing bolts: typically 8–12 Nm. Aluminum threads strip easily — verify spec and use a torque wrench.

Pro tip: Bleed the cooling system per the factory procedure after refilling, or trapped air will overheat the engine and fake a “still broken” reading.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →