Diagnose soonStarts moderate but can progress to severe rapidly - wrong line pressure burns clutches. Fix promptly, avoid hard acceleration and towing.
The D pressure control solenoid is not performing or is stuck off - wrong line pressure means slipping or limp mode.
Model notes: An online parts-catalog tip: some Toyota/Lexus catalogs label the pressure solenoids as #1, #2, #3 or 3-way rather than A/B/C/D - check the transmission-specific parts diagram to identify solenoid D on these vehicles.
Key facts
P2714 means pressure Control Solenoid D Performance or Stuck Off. The D pressure control solenoid is not performing or is stuck off - wrong line pressure means slipping or limp mode. WrenchFair's published fair-price range for this repair is $60–$900 parts and $150–$1500 labor at independent shops.
WrenchFair rates P2714 a 4-of-5 DIY difficulty (“Fluid/filter service and wiring checks are DIY; pressure solenoid or valve body work needs pan removal and transmission-specific knowledge.”) with a “Diagnose soon” driveability rating: Starts moderate but can progress to severe rapidly - wrong line pressure burns clutches. Fix promptly, avoid hard acceleration and towing. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2014–2019 Chevrolet Spark (1.2L LL0 I4, 1.4L LV7 I4) — CVT shudder / jerk (P0871, P2714):Owner-verified
The pressure switch lives inside the control solenoid valve assembly (valve body) and is not separately serviceable. Fluid check is from below at the level-check plug with the transmission at operating temperature. Valve-body replacement is a pan-off job best done at the dealer under the extended coverage.
Do this test first: Research Technical Service Bulletins for the specific vehicle by year, model, and transmission.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P2714 on the 2014–2019 Chevrolet Spark — but the community-sourced CVT shudder / jerk (P0871, P2714) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
CVT pan bolts: verify — Pan bolt torque not confirmed from a forum source — confirm against factory service info before torquing; check fluid at the level plug with the CVT at operating temperature.
Tips
Know the symptom pattern: jerking or shuddering in normal driving, hesitation launching from a stop, RPM hunting without speed gain, and sometimes the engine stalling — often with the check-engine light and P0871 (pressure switch 3), P2714 (pressure control solenoid 4), P0741, P0841, or P0965 in the TCM. GM references PIP5521A for these codes.
Check the fluid first. The pressure switch fails from debris in the fluid, and if P0871 sets intermittently, a fluid change can clear it. The switch is integrated into the valve body with no serviceable parts — persistent codes mean replacing the whole control solenoid valve assembly.
GM extended CVT coverage to 10 years / 120,000 miles, so valve-body or transmission work should be free — confirm by VIN with a dealer before paying anything. One owner had the whole CVT replaced free at 52k miles under the powertrain warranty.
Despite GM calling the fluid 'lifetime,' the Spark owner community's standing advice is a drain-and-fill every 18,000-25,000 miles, plus a pan-magnet check for debris — early contamination is the documented killer of the pressure-relief valve and oil pump.
Driving habits matter on this Jatco CVT7: let it warm up a few minutes in cold weather, ease onto the throttle from stops rather than flooring it, and know the fake 'shift' step under hard throttle is programmed behavior, not a fault.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
vehicle enters limp mode
transmission slips when shifting
transmission overheating
transmission catches in gear
decreased fuel economy
possible misfire-like symptoms
check engine light illuminated
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Defective pressure control solenoid
Dirty or contaminated fluid
Dirty or clogged transmission filter
Defective transmission pump
Defective transmission valve body 3 owner notes link this repair to P2714
Restricted hydraulic passages
Corroded or damaged connector
Faulty or damaged wiring
Faulty PCM
Owner notes linked to P2714: 3 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 7 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Research Technical Service Bulletins for the specific vehicle by year, model, and transmission. Tests: Dirty or clogged transmission filter
Check vehicle records to verify the last time the filter and fluid were changed.
Check the fluid level and examine the fluid condition for contamination.
Perform a detailed visual inspection of the wiring for obvious defects; check connectors and connections for security, corrosion, and damaged pins - including all wiring to the pressure control solenoids, transmission pump, and PCM. Tests: Defective pressure control solenoid
Common repairs: changing the fluid and filter, replacing the faulty pressure control solenoid, repairing or replacing the transmission pump or valve body, flushing to clean passages, cleaning connector corrosion, repairing wiring.
Beware of misdiagnosis: engine misfire, transmission pump problem, internal transmission problem, or driveline problem can mimic this code.
Advanced diagnosis needs a digital multimeter and the vehicle-specific troubleshooting guidelines (voltage and fluid pressure requirements vary by model). Perform continuity checks with power removed - normal wiring/connections should read 0 ohms.
Most likely job on your 2014–2019 Chevrolet Spark: CVT shudder / jerk (P0871, P2714) — test first, then buy for this job.
The price range below is a national planning range for P2714 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$60 – $900
Labor$150 – $1500
Fluid/filter service or pressure control solenoid replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2714 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Fluid/filter service and wiring checks are DIY; pressure solenoid or valve body work needs pan removal and transmission-specific knowledge.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →