Diagnose soonStarts moderate but can progress to severe rapidly - wrong line pressure burns clutches. Fix promptly, avoid hard acceleration and towing.
The D pressure control solenoid is not performing or is stuck off - wrong line pressure means slipping or limp mode.
Model notes: An online parts-catalog tip: some Toyota/Lexus catalogs label the pressure solenoids as #1, #2, #3 or 3-way rather than A/B/C/D - check the transmission-specific parts diagram to identify solenoid D on these vehicles.
Key facts
P2714 means pressure Control Solenoid D Performance or Stuck Off. The D pressure control solenoid is not performing or is stuck off - wrong line pressure means slipping or limp mode. WrenchFair's published fair-price range for this repair is $60–$900 parts and $150–$1500 labor at independent shops.
WrenchFair rates P2714 a 4-of-5 DIY difficulty (“Fluid/filter service and wiring checks are DIY; pressure solenoid or valve body work needs pan removal and transmission-specific knowledge.”) with a “Diagnose soon” driveability rating: Starts moderate but can progress to severe rapidly - wrong line pressure burns clutches. Fix promptly, avoid hard acceleration and towing. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 2,203 factory bulletins on file for this vehicle (mostly Equipment, Electrical System, Engine And Engine Cooling) — see the latest ones
On your 2019–2025 Chevrolet Malibu (1.5L Turbo (CVT)) — CVT slip / loss of drive — valve body (P2714):Owner-verified
Valve body is inside the transmission — dealer-level work. Owners can check the fluid level via the level plug (there is no dipstick) and document symptoms.
Do this test first: Research Technical Service Bulletins for the specific vehicle by year, model, and transmission.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P2714 on the 2019–2025 Chevrolet Malibu — but the community-sourced CVT slip / loss of drive — valve body (P2714) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Valve body / transmission fasteners: verify — Dealer-level repair — torque specs not confirmed from a forum source; confirm against factory service info.
Tips
Symptom pattern: slipping, shuddering, hesitation, delayed acceleration, or sudden loss of forward drive — sometimes with reduced-engine-power warnings, sometimes with no warning at all. DTC P2714 (clutch regulator valve stuck off) stored in the transmission control module.
GM TSB 24-NA-009 names the cause: the clutch regulator valve sticks in the valve body, which can damage the forward clutch piston and wear the primary pulley bearing bore. The TSB repair ladder is: borescope the chain and sheaves (transmission replacement ONLY if they're damaged) → verify P2714 and fluid level at the correct temperature → if slip is confirmed, replace the valve body and reassess.
Do not authorize a full transmission on a P2714 slip alone: an owner thread documents a dealer quoting $6,400 for a transmission when the TSB path is the valve body. Cite TSB 24-NA-009 and ask whether the dealer followed its ladder before approving anything.
Owner-side check: verify the fluid level correctly (at operating temperature via the level plug) — low fluid mimics slip. Use only the specified CVT fluid; owners discuss Mobil 1 LV ATF as the correct-spec fluid for this unit.
Context: a class action filed September 2026 alleges GM knew of the CVT defect since 2021 (2019–2025 Malibu). Keep every repair receipt and quote.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
vehicle enters limp mode
transmission slips when shifting
transmission overheating
transmission catches in gear
decreased fuel economy
possible misfire-like symptoms
check engine light illuminated
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Defective pressure control solenoid
Dirty or contaminated fluid
Dirty or clogged transmission filter
Defective transmission pump
Defective transmission valve body 3 owner notes link this repair to P2714
Restricted hydraulic passages
Corroded or damaged connector
Faulty or damaged wiring
Faulty PCM
Owner notes linked to P2714: 3 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 7 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Research Technical Service Bulletins for the specific vehicle by year, model, and transmission. Tests: Dirty or clogged transmission filter
Check vehicle records to verify the last time the filter and fluid were changed.
Check the fluid level and examine the fluid condition for contamination.
Perform a detailed visual inspection of the wiring for obvious defects; check connectors and connections for security, corrosion, and damaged pins - including all wiring to the pressure control solenoids, transmission pump, and PCM. Tests: Defective pressure control solenoid
Common repairs: changing the fluid and filter, replacing the faulty pressure control solenoid, repairing or replacing the transmission pump or valve body, flushing to clean passages, cleaning connector corrosion, repairing wiring.
Beware of misdiagnosis: engine misfire, transmission pump problem, internal transmission problem, or driveline problem can mimic this code.
Advanced diagnosis needs a digital multimeter and the vehicle-specific troubleshooting guidelines (voltage and fluid pressure requirements vary by model). Perform continuity checks with power removed - normal wiring/connections should read 0 ohms.
Most likely job on your 2019–2025 Chevrolet Malibu: CVT slip / loss of drive — valve body (P2714) — test first, then buy for this job.
The price range below is a national planning range for P2714 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$60 – $900
Labor$150 – $1500
Fluid/filter service or pressure control solenoid replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2714 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Fluid/filter service and wiring checks are DIY; pressure solenoid or valve body work needs pan removal and transmission-specific knowledge.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →