Diagnose soonSevere code - the cooling system is compromised and the engine can overheat. Do not drive if the temperature gauge climbs or fans run at full speed constantly.
The second electric coolant pump is not performing right - the pump or its circuit is failing, so the engine can overheat.
Key facts
P261B means coolant Pump B Control Circuit Range/performance. The second electric coolant pump is not performing right - the pump or its circuit is failing, so the engine can overheat. WrenchFair's published fair-price range for this repair is $100–$400 parts and $100–$400 labor at independent shops.
WrenchFair rates P261B a 3-of-5 DIY difficulty (“Visual inspection and relay checks are DIY; pump resistance and circuit tests need a multimeter; PCM is shop-level.”) with a “Diagnose soon” driveability rating: Severe code - the cooling system is compromised and the engine can overheat. Do not drive if the temperature gauge climbs or fans run at full speed constantly. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2010–2015 Toyota Prius (1.8L 2ZR-FXE hybrid) — Electric engine water pump failure (P261B, overheat):Owner-verified
Front of the engine, accessible from below/behind. This is an easy DIY job with basic hand tools — drain coolant, swap the pump, refill and bleed. The inverter has its own separate electric pump; don't mix them up.
Do this test first: Check for Technical Service Bulletins for the specific vehicle - it may be a known issue with a known fix.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P261B on the 2010–2015 Toyota Prius — but the community-sourced Electric engine water pump failure (P261B, overheat) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Water pump fasteners: verify — Torque specs not confirmed from a forum source — confirm against factory service info before torquing.
Tips
Gen 3 went to a 100% electric engine water pump, and the failure point is the plastic impeller, not the motor — it stops moving coolant, the engine overheats, and on this generation that overheating is one of the paths to a blown head gasket. The codes are P261B/P261C.
The tells: the temperature warning light (there is no low-coolant light, only a high-temp warning), unexplained coolant loss, or pink coolant sprayed under the hood near the overflow tank. Catch it at the warning light, not at the steam.
If you get P261B, stop driving and replace the pump — the DIY video owners reference calls it a straightforward job, and the part is a few hundred dollars for OEM or Aisin. Driving on it risks turning a pump job into a head gasket job.
Buy OEM or Aisin — owners warn that aftermarket electric pumps are a gamble on longevity, and the pump is cheap relative to what a failure costs downstream.
Refill and bleed carefully; air in the engine coolant loop is the classic post-replacement mistake. Run the car with the reservoir cap off until the level stabilizes.
Typical difficulty: Moderate — based on 294 code guides for the cooling repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
malfunction indicator light on
overheating
a/c system not functioning properly
cooling fans running constantly at full speed
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Open in the circuit to the coolant pump
Failed coolant pump (inoperative mechanically or electrically, stuck impeller)
Failed or corroded pump relay or relay connections
Damaged or corroded wiring or connector
Failed PCM (unlikely)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 9 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check for Technical Service Bulletins for the specific vehicle - it may be a known issue with a known fix.
Locate Coolant Pump B (usually mounted to the front or top of the engine, inside a wheel well, or against the bulkhead). Tests: Open in the circuit to the coolant pump
Inspect the pump connector, wiring, and the pump relay and its connections for damage, corrosion, burn spots, or melted plastic - relays and their connections are the most common concern. Tests: Failed or corroded pump relay or relay connections
Clean terminals with electrical contact cleaner and a plastic bristle brush, dry, and apply electrical grease.
Clear the code with a scan tool; if it does not return, the connection was the problem.
If it returns, disconnect the pump harness and check pump motor resistance with a digital multimeter against manufacturer specs - open or shorted means replace the coolant pump; a mechanically stuck impeller also means replacement.
With the pump commanded on (scan tool actuator function), verify 12 V at the pump power supply circuit; repair wiring from the PCM or relay if missing.
Verify a good ground at the pump with a test light while actuating it; wiggle the harness to catch intermittent connections.
If all tests pass, the coolant pump has likely failed - replace it. PCM failure is unlikely.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2010–2015 Toyota Prius: Electric engine water pump failure (P261B, overheat) — test first, then buy for this job.
The price range below is a national planning range for P261B on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$100 – $400
Labor$100 – $400
Electric coolant pump replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P261B ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Visual inspection and relay checks are DIY; pump resistance and circuit tests need a multimeter; PCM is shop-level.
Torque specs: Thermostat housing bolts: typically 8–12 Nm. Aluminum threads strip easily — verify spec and use a torque wrench.
Pro tip: Bleed the cooling system per the factory procedure after refilling, or trapped air will overheat the engine and fake a “still broken” reading.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →