Diagnose soonSevere code - a control circuit problem can cause very poor running engine and drivability issues. Rectify as quickly as possible.
The upstream O2 sensor on bank 1 has too low a reading on its positive current control circuit - the sensor cannot report exhaust oxygen properly.
Model notes: Seen on 2011 Lexus RX350, 1999 VW Passat 1.8T, 2007 Lexus ES300, 2004 Toyota Sienna, 2004 Toyota RAV4 2.0 VVT-i. Also common on Mazda, VW, Acura, Kia, Toyota, BMW, Peugeot, Lexus, Audi.
Key facts
P2238 means o2 sensor positive current control circuit low bank 1 sensor 1. The upstream O2 sensor on bank 1 has too low a reading on its positive current control circuit - the sensor cannot report exhaust oxygen properly. WrenchFair's published fair-price range for this repair is $50–$200 parts and $50–$150 labor at independent shops.
WrenchFair rates P2238 a 3-of-5 DIY difficulty (“Visual inspection and O2 sensor replacement are intermediate work; resistance testing between circuits requires electrical familiarity.”) with a “Diagnose soon” driveability rating: Severe code - a control circuit problem can cause very poor running engine and drivability issues. Rectify as quickly as possible. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 610 factory bulletins on file for this vehicle (mostly Equipment, Electrical System, Structure) — see the latest ones
On your 2018–2024 Toyota Camry (2.5L 4-cyl (A25A-FKS)) — O2 (oxygen) sensors:Owner-verified
Bank 1 Sensor 1 (upstream) is a wideband air-fuel ratio sensor, not a conventional narrowband O2 — the downstream is the heated oxygen sensor (per the factory service manual's monitor description). TRQ's video walkthrough covers the upstream sensor replacement for the full 2018-2024 Camry range, demonstrated on a 2022 LE 2.5L AWD. Soak the sensor threads with rust penetrant well before the attempt — seized threads are the known pain point on these sensors.
Do this test first: Retrieve all stored codes and freeze frame data; clear the codes and test drive.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P2238 on the 2018–2024 Toyota Camry — but the community-sourced O2 (oxygen) sensors note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Air-fuel ratio sensor (upstream): verify — Install torque not found in the indexed Camry XV70 manual pages (44 Nm is published for the same A25A-FKS engine in the RAV4 manual, but is not vehicle-verified for the Camry); verify against factory service manual before torquing.
Tips
Apply anti-seize to the new sensor's threads before installation.
Use a dedicated O2 sensor socket; a pocket screwdriver helps release the wiring connector without breaking it.
After replacement, perform the factory 'Inspection After Repair' procedure — the service manual lists it as required when an air-fuel ratio sensor is replaced.
Typical difficulty: Moderate — based on 841 code guides for the sensors repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
reduction in fuel efficiency
diminished engine performance
stored misfire codes or lean/rich exhaust codes
check engine light on
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Defective oxygen sensor
Burnt, chafed, broken, or disconnected wiring or connectors
Faulty PCM or PCM programming error
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Retrieve all stored codes and freeze frame data; clear the codes and test drive.
Perform a visual inspection of HO2S related wiring and connectors - replace cut, burned, or damaged wiring. Tests: Burnt, chafed, broken, or disconnected wiring or connectors
Unplug the HO2S and use the DVOM to check resistance between the positive current control circuit and ground circuits - continuity suggests a defective HO2S. Tests: Defective oxygen sensor
Start the engine, allow it to reach normal operating temperature, and observe oxygen sensor input data on the scanner. Tests: Defective oxygen sensor
If the HO2S displays battery voltage or no voltage, test live data at the HO2S connector; if unchanged, suspect an internal HO2S short and replace the sensor.
Consider a faulty PCM or programming error only after the sensor and wiring check out.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2018–2024 Toyota Camry: O2 (oxygen) sensors — test first, then buy for this job.
Expensive fork: Catalytic converter — only if the downstream waveform shows a dead cat after a good sensor and no exhaust leak.
The price range below is a national planning range for P2238 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$50 – $200
Labor$50 – $150
Oxygen sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2238 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Visual inspection and O2 sensor replacement are intermediate work; resistance testing between circuits requires electrical familiarity.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →