Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonNot a drivability problem, but in real winter cold this is your cabin heat and defroster - fix it before the temperature drops.
Your diesel has a little auxiliary fuel burner that heats the coolant for cabin heat in extreme cold, and it is not heating as well as the computer expects. You will notice weak cabin heat in very cold weather - the engine itself is fine.
Key facts
P2030 means fuel fired heater performance. Your diesel has a little auxiliary fuel burner that heats the coolant for cabin heat in extreme cold, and it is not heating as well as the computer expects. You will notice weak cabin heat in very cold weather - the engine itself is fine. WrenchFair's published fair-price range for this repair is $80–$800 parts and $150–$500 labor at independent shops.
WrenchFair rates P2030 a 4-of-5 DIY difficulty (“This is a niche diesel cold-climate system; sensor and wiring checks are DIY-able, but burner and igniter testing needs the factory diagnostic flow and often manual heater activation.”) with a “Diagnose soon” driveability rating: Not a drivability problem, but in real winter cold this is your cabin heat and defroster - fix it before the temperature drops. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light on
no heat in the passenger compartment in cold weather
excessive heat in the passenger compartment on some vehicles
climate control blower temporarily disabled
no symptoms in warm weather
Likely causes
Defective temperature sensor (air or coolant) misreporting heater performance (most common)
Bad fuel fired heater injector
Faulty fuel fired heater burner or igniter
Shorted or open wiring or connectors in the fuel fired heater circuit
Faulty PCM or programming error (rare)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check for technical service bulletins for your make and model.
Retrieve all codes and freeze-frame data, record it, clear the codes, and test drive to see if P2030 resets.
Test the heater temperature sensors (air and/or coolant) with a multimeter against the factory specs. Tests: Defective temperature sensor (air or coolant) misreporting heater performance (most…
Activate the heater manually with a scan tool if the weather will not trigger it, and test the heater injector and igniter. Tests: Bad fuel fired heater injector
If those pass, test the input and output signal circuits from the fuse panel, PCM, and ignition switch with the controllers disconnected.
Only suspect the PCM after sensors, injector, igniter, and circuits are all proven good.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$80 – $800
Labor$150 – $500
Fuel fired heater temperature sensor or burner repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2030 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — This is a niche diesel cold-climate system; sensor and wiring checks are DIY-able, but burner and igniter testing needs the factory diagnostic flow and often manual heater activation.
Torque specs: Thermostat housing bolts: typically 8–12 Nm. Aluminum threads strip easily — verify spec and use a torque wrench.
Pro tip: Bleed the cooling system per the factory procedure after refilling, or trapped air will overheat the engine and fake a “still broken” reading.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →