Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonMaximum-pressure failsafe shifting bangs the drivetrain - get it diagnosed before it beats up the transmission.
Your transmission's B pressure sensor is reading too low - usually a shorted wire. The computer may overcompensate with harsh, slamming shifts.
Key facts
P0847 means transmission fluid pressure sensor/switch B circuit low. Your transmission's B pressure sensor is reading too low - usually a shorted wire. The computer may overcompensate with harsh, slamming shifts. WrenchFair's published fair-price range for this repair is $80–$350 parts and $200–$500 labor at independent shops.
WrenchFair rates P0847 a 4-of-5 DIY difficulty (“Connector inspection first - the sensor itself is often under the pan.”) with a “Diagnose soon” driveability rating: Maximum-pressure failsafe shifting bangs the drivetrain - get it diagnosed before it beats up the transmission. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
harsh, slamming shifts
limp mode
check-engine light on
Likely causes
Signal wire shorted to ground (most common)
Failed pressure sensor/switch B stuck low
Corroded connector bridging the signal to ground
Chafed harness at the transmission case
Failed PCM/TCM (rare)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check for TSBs and companion codes; diagnose power faults first.
Check fluid level and condition.
Inspect the sensor connector and transmission harness for chafing, corrosion, and pin damage. Tests: Chafed harness at the transmission case
Disconnect the sensor and see if the low signal clears - if it does, the sensor is the short.
With power removed, test the signal wire for continuity to ground; repair the shorted section.
Clear the code and confirm the pressure reading responds normally on live data.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$80 – $350
Labor$200 – $500
Transmission fluid pressure sensor/switch replacement or shorted-wiring repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0847 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Connector inspection first - the sensor itself is often under the pan.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →