P0560

P0560 on a 2018–2024 Toyota Camry: System voltage malfunction

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0560 on a 2014–2019 Chevrolet Silverado 1500 · 2015–2020 Ford F-150 · 2018–2022 Honda Accord · 2016–2021 Honda Civic · 2017–2022 Honda CR-V · 2021–2026 Nissan Rogue
Show all 10 vehicles with this code

2019–2026 Ram 1500 · 2018–2024 Toyota Camry · 2019–2026 Toyota Corolla · 2019–2024 Toyota RAV4

DIY difficulty 2/5

Can I drive with P0560?

Can I drive with a P0560 code?

Short trips and gentle driving only, until you know the cause. The car can die without warning once the battery depletes. Get the charging system tested promptly. If the check-engine light starts flashing, the engine shakes badly, or the car loses significant power, pull over safely and have it towed.

How serious is P0560?

Moderate. WrenchFair rates this one “Diagnose soon” — the car can usually get you home, but driving on it can turn a cheap fix into an expensive one. The car can die without warning once the battery depletes. Get the charging system tested promptly.

Will P0560 go away on its own?

The warning light can turn off by itself after clean drive cycles, but the code stays stored in the computer's memory and the fault is still there. Clearing it without fixing the cause just buys time — it will come back when the computer re-runs the self-test. Exception: a loose gas cap — tighten it and drive a few days.

Your car's electrical voltage is out of whack - too high or too low. Low voltage alone can cause a Christmas tree of warning lights and weird behavior across the whole car.

Model notes: Fix voltage problems before chasing any other codes - low voltage creates phantom faults everywhere, and they all vanish once voltage is correct.

Key facts

☑ Before you buy parts — check these first:
On your 2018–2024 Toyota Camry (2.5L 4-cyl (A25A-FKS)) — Battery replacement: Owner-verified
12V battery is in the engine bay on the right (passenger) side of the vehicle. Correct group size is H5 (BCI Group 47); confirm terminal layout before buying. Terminal clamp bolts are 10 mm; the hold-down bracket bolt is 12 mm (use an extension). Disconnect negative terminal first, then positive; reverse on install (positive first, then negative).
Do this test first: Measure battery voltage: ~12.6V engine off, ~13.5-14.8V running
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0560 on the 2018–2024 Toyota Camry — but the community-sourced Battery replacement note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: MobileBattery — 2018 Toyota Camry battery replacement (right-side location, Group H5, 10 mm terminals, 12 mm hold-down) · YouTube — reset idle after disconnecting battery terminal (Toyota Camry, ~2000 RPM for ~5 min fuel-trim relearn) · YouTube — Toyota/Lexus rough idle after battery change: idle reset relearn procedure (Camry) · YouTube — Toyota/Lexus window reset (hold 5 sec at bottom, 5 sec at top; happens after battery change) · YouTube — 2018-2023 Toyota Camry battery replacement (2.5L & 3.5L how-to) · Jerry Lambert Automotive — How to reset systems after battery replacement (memory saver, window recalibration)

Typical difficulty: Involved — based on 854 code guides for the battery repair area (an area-level estimate, not this exact job).

Typical time: “Rough/stalling idle after a disconnect is common on Toyotas: with the engine warm, hold it around 2000 RPM in drive for about 5 minutes so the ECU relearns fuel trims and idle (idle-reset walkthrough).” — as written in the note. First-timers often take twice this.

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Owner notes linked to P0560: 10 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Measure battery voltage: ~12.6V engine off, ~13.5-14.8V running Tests: Weak or dying battery
  2. Clean battery terminals and check cable condition Tests: Corroded battery terminals or cables
  3. Load-test the battery - voltage alone doesn't prove health Tests: Weak or dying battery
  4. If running voltage is out of range with a good battery, test or replace the alternator Tests: Failing alternator (most common)

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2018–2024 Toyota Camry: Battery replacement — test first, then buy for this job.
The price range below is a national planning range for P0560 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$100 – $500
Labor$100 – $350

Battery is $150-250; alternator replacement runs more. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0560 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Battery and charging tests are basic DIY; interpret multiple codes with suspicion until voltage is proven good.

Watch this repair on YouTube

Parts & tools

Battery & charging toolkit — what the job actually takes

Torque specs: Terminal clamps: snug, typically 5–8 Nm. Over-tightening cracks the battery post.

Pro tip: Disconnect negative first, reconnect negative last. On module-heavy cars use a memory saver so you don’t lose radio codes and adaptations.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →