Drive safeEmissions-only fault. Safe to drive - fix at your convenience (often just the gas cap).
Your gas cap is loose or missing - that's the most common cause by far. Tighten it until it clicks and the light may go off on its own after a few drives.
Model notes: This is the 'you left the cap loose' code - it is designed to be the easy one. Always start with the cap and give the self-test time to run before further diagnosis.
Key facts
P0457 means evaporative emission control system leak detected (fuel cap loose/off). Your gas cap is loose or missing - that's the most common cause by far. Tighten it until it clicks and the light may go off on its own after a few drives. WrenchFair's published fair-price range for this repair is $15–$80 parts and $0–$180 labor at independent shops.
WrenchFair rates P0457 a 1-of-5 DIY difficulty (“Tighten or replace the gas cap first - this code exists specifically for that scenario.”) with a “Drive safe” driveability rating: Emissions-only fault. Safe to drive - fix at your convenience (often just the gas cap). These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Emissions warranty: p0457 is emissions-related — federal law requires up to 8 years / 80,000 miles of coverage on the catalytic converter, engine computer and OBD system. Check if your repair might be free before you pay for it.
On your 2013–2020 Ford Fusion (2.5L Duratec I4, 1.5L EcoBoost I4, 1.6L EcoBoost I4, 2.0L EcoBoost I4, 2.7L EcoBoost V6) — “Check Fuel Fill Inlet” — capless Easy Fuel flap not sealing (P0456/P0457):Owner-verified
Everything happens at the fuel door — no tools needed for the funnel procedure. The funnel ships with the car in the spare-tire area; if yours is missing, any fuel filler funnel that fits the capless inlet works.
Do this test first: Tighten the gas cap until it clicks several times, or replace it if the seal is damaged or the cap is missing
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for p0457 on the 2013–2020 Ford Fusion — but the community-sourced “Check Fuel Fill Inlet” — capless Easy Fuel flap not sealing (P0456/P0457) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Tips
A “Check Fuel Fill Inlet” message on the cluster — sometimes followed by a check-engine light with P0456 or P0457 — is the capless Easy Fuel system's way of saying its spring-loaded filler flap isn't sealing. Dirt, ice, or a worn seal lets fuel vapor escape, which the EVAP monitor reads as a leak.
The owner's-manual fix works surprisingly often: pull over safely, engine off, open the fuel door, clear any visible debris, then insert the fuel funnel (stored with the spare tire) into the filler several times to dislodge grit and reseat the flap. It can take several drive cycles for the message to clear after the fix.
For a stubborn flap, owners report success cleaning the sealing area and applying a light silicone-safe lubricant, then working the flap open and closed a few times. Don't force anything down into the tank — and don't top off past the pump's first click, which floods the EVAP system and sets its own codes.
If the message keeps returning after cleaning, the filler-neck seal itself may be worn. That's a filler-neck replacement — still a driveway job (a few bolts and hose clamps) — but get a smoke test confirming the leak location before buying parts.
Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light
fuel smell
failed emissions test
no drivability symptoms
slightly worse fuel mileage
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Loose, missing, or damaged gas cap (most common by far)
Cracked filler neck
Large disconnected EVAP hose
Stuck-open vent valve 3 owner notes link this repair to P0457
Owner notes linked to P0457: 3 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Tighten the gas cap until it clicks several times, or replace it if the seal is damaged or the cap is missing Tests: Loose, missing, or damaged gas cap (most common by far)
Clear the code and drive normally - the EVAP self-test needs specific conditions and may take a few drive cycles
If the code returns with a good cap, smoke-test for a large leak elsewhere
Inspect the filler neck for cracks or rust holes Tests: Cracked filler neck
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2013–2020 Ford Fusion: “Check Fuel Fill Inlet” — capless Easy Fuel flap not sealing (P0456/P0457) — test first, then buy for this job.
The price range below is a national planning range for p0457 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$15 – $80
Labor$0 – $180
Gas cap is under $25; smoke test plus hose/valve runs more. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0457 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
1 of 5 — Tighten or replace the gas cap first - this code exists specifically for that scenario.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →