P0418

P0418 on a 2009–2015 Toyota Tacoma: Secondary Air Injection System Relay A Circuit

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0418 on a 2010–2024 Toyota 4Runner · 2009–2015 Toyota Tacoma

DIY difficulty 1/5

The relay that switches the air pump on and off has an electrical problem in its control circuit. The pump itself may be perfectly fine - start with the relay, its fuse, and the wiring, because this code is about the switch, not the pump.

Key facts

☑ Before you buy parts — check these first:
On your 2009–2015 Toyota Tacoma (4.0L 1GR-FE V6, 2.7L 2TR-FE I4) — Secondary air injection failure (P2440/P0418): Owner-verified
The air switching valve sits on the side of the engine head near the exhaust manifold (12mm nuts, one tucked behind the valve); the pump and relay live in the engine-bay fuse/relay area. No intake removal needed for the relay test.
Do this test first: Scan for all codes and record freeze-frame data, then clear the code and test-drive to see if it returns.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0418 on the 2009–2015 Toyota Tacoma — but the community-sourced Secondary air injection failure (P2440/P0418) note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: owner forum · owner forum · owner forum

Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).

Typical time: “Out of warranty, the owner consensus is the Hewitt-Tech bypass kit (~$145, about an hour to install, splices into the MAF harness) versus roughly $2,500 for the dealer's whole-system replacement — multiple owners report…” — as written in the note. First-timers often take twice this.

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Scan for all codes and record freeze-frame data, then clear the code and test-drive to see if it returns.
  2. Check the related fuses and relays before condemning any part - an open fuse is a cheap fix. Tests: open or shorted wiring in the relay control circuit
  3. Swap the air pump relay with an identical relay from a non-critical circuit and see if the code clears. Tests: blown fuse in the air pump circuit
  4. Inspect the relay socket for corrosion or melted plastic. Tests: corroded relay socket or connector
  5. Visually inspect the wiring, connectors, and hoses around the component for damage, corrosion, chafing, loose pins, or disconnection.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2009–2015 Toyota Tacoma: Secondary air injection failure (P2440/P0418) — test first, then buy for this job.
The price range below is a national planning range for P0418 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$15 – $60
Labor$50 – $100

Secondary air pump relay replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0418 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

1 of 5 — Relay swap and fuse check - one of the easiest codes to diagnose.

Watch this repair on YouTube

Parts & tools

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →