P0358

P0358 on a 2014–2018 GMC Sierra 1500: Ignition coil 'H' primary/secondary circuit

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0358 on a 2014–2018 GMC Sierra 1500

DIY difficulty 2/5

The ignition coil for cylinder 8 has an electrical fault.

Key facts

☑ Before you buy parts — check these first:
On your 2014–2018 GMC Sierra 1500 (5.3L V8) — Spark plugs and ignition coils: Owner-verified
The 5.3L EcoTec3 (L83) uses coil-near-plug ignition: 8 individual coils bolted to the valve covers, each connected to its spark plug by a SHORT plug wire routed through a metal heat-shield boot — not true coil-on-plug. Driver's side cylinders front-to-back are 1, 3, 5, 7; passenger side are 2, 4, 6, 8. Most plugs are reachable from above; the rear passenger-side #8 plug (tight against the firewall) is the problem child — use a short (3.5-4 inch) magnetic swivel 5/8-inch spark plug socket over the top, or pull the flexible passenger-side wheel-well liner back for a direct angle at the #8 boot. Tools used in the Sierra-specific 1A Auto walkthrough: 8mm socket (coil bolts), hose pliers (boot removal), 5/8-inch spark plug socket and extensions. The OE plug for the 5.3L is ACDelco 41-114 (GM 12622441), pre-gapped 0.040 in. GM issued service update 14-481 for 2014 Silverado/Sierra LD 5.3/6.2L: loose plug wires at the coil or plug end cause P0300 misfires — pull and firmly reseat every wire at both ends, and reinstall the metal heat shields on the boots.
Do this test first: Swap coil H with another cylinder's coil
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0358 on the 2014–2018 GMC Sierra 1500 — but the community-sourced Spark plugs and ignition coils note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: 1A Auto: How to Replace Spark Plugs 2014-2018 GMC Sierra 1500 5.3L V8 · GMTNation: Silverado-Sierra engine/driveline torque values (spark plug 15/11 lb-ft) · TahoeYukonForum (K2XX): #8 plug access via wheel-well liner and short swivel socket · DMoney Garage: Spark plug + wire replacement on 2014 GMC Sierra 5.3L (cylinder numbering, heat shields) · ACDelco 41-114 plug spec: pre-gapped 0.040 in, do not re-gap iridium · GM service update 14-481: loose spark plug wires cause P0300 on 2014 Silverado/Sierra LD · NGK tech bulletin NGKSP-0907-1R: anti-seize not recommended on plated plugs

Typical difficulty: Easy — based on 64 code guides for the ignition repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Swap coil H with another cylinder's coil
  2. Check the coil connector Tests: Damaged wiring or corroded connector
  3. Test coil power and ground
  4. Replace the coil if the fault follows it

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2014–2018 GMC Sierra 1500: Spark plugs and ignition coils — test first, then buy for this job.

Expensive fork: Fuel injector, then compression test — if the misfire stays on the same cylinder after a fresh plug and a swapped coil. The price range below is a national planning range for P0358 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$40 – $150
Labor$50 – $150

Ignition coil replacement (coil H). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0358 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Swap the coil with another cylinder.

Watch this repair on YouTube

Parts & tools

Spark plug & coil toolkit — what the job actually takes

Torque specs: Gasket-seat plugs: typically 20–30 Nm (15–22 lb-ft). Tapered-seat plugs: typically 11–18 Nm. Always verify against your engine’s factory spec — over-torquing strips aluminum threads.

Pro tip: Blow out the plug wells with compressed air BEFORE removing the plugs, so debris can’t fall into the cylinders.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →