Diagnose soonIf the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter.
The ignition coil for cylinder 7 has an electrical fault.
Key facts
P0357 means ignition coil 'G' primary/secondary circuit. The ignition coil for cylinder 7 has an electrical fault. WrenchFair's published fair-price range for this repair is $40–$150 parts and $50–$150 labor at independent shops.
WrenchFair rates P0357 a 2-of-5 DIY difficulty (“Swap the coil with another cylinder.”) with a “Diagnose soon” driveability rating: If the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 2,481 factory bulletins on file for this vehicle (mostly Electrical System, Equipment, Power Train) — see the latest ones
On your 2011–2021 Jeep Grand Cherokee (5.7L HEMI V8) — Spark plugs and ignition coils:Owner-verified
16 spark plugs — 2 per cylinder. Remove engine cover, intake hose with airbox lid, and disconnect the air sensor. The front 3 plugs on the passenger side are in plain view and take ~20 minutes with a 5/8" plug socket. Driver's side is harder: use a ratcheting wrench on the driver-side brackets, and an inverted Torx socket to remove the entire stud through the top of the bracket to the intake plenum if needed. Rear driver's-side plugs are the worst of the 16 — lay a thick blanket over the engine to lean across it. Do one cylinder at a time to minimize dirt entering the chamber; turn new plugs counter-clockwise until they 'click' to seat threads before tightening.
Do this test first: Swap coil G with another cylinder's coil
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0357 on the 2011–2021 Jeep Grand Cherokee — but the community-sourced Spark plugs and ignition coils note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Spark plugs: 13 ft-lbs (156 in-lbs) — Per service manual cited on RamForum; service manual warns the HEMI plug is a torque-critical tapered design — do not exceed 15 ft-lbs. Independently confirmed for 2011-2013 WK2 5.7 by second source.
Tips
Light smear of anti-seize on plug threads and dielectric grease on the coil boot end; service interval 30k miles (copper plugs).
Blow out plug wells before removing plugs — debris falls in otherwise (common cause of engine damage).
Factory coils are good — dealers/owners typically don't replace coils with plugs unless a coil code is set.
Coil bolts and connector clips are the usual frustration points; keep coil boots/seals from falling into the bay.
Typical difficulty: Easy — based on 64 code guides for the ignition repair area (an area-level estimate, not this exact job).
Typical time: “The front 3 plugs on the passenger side are in plain view and take ~20 minutes with a 5/8" plug socket.” — as written in the note. First-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light (may flash)
misfire on cylinder 7
rough idle
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failed ignition coil G (most common)
Damaged wiring or corroded connector
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Swap coil G with another cylinder's coil
Check the coil connector Tests: Damaged wiring or corroded connector
Test coil power and ground
Replace the coil if the fault follows it
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2011–2021 Jeep Grand Cherokee: Spark plugs and ignition coils — test first, then buy for this job.
Expensive fork: Fuel injector, then compression test — if the misfire stays on the same cylinder after a fresh plug and a swapped coil.
The price range below is a national planning range for P0357 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$40 – $150
Labor$50 – $150
Ignition coil replacement (coil G). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0357 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →