Diagnose soonIf the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter.
The ignition coil for cylinder 6 has an electrical fault.
Key facts
P0356 means ignition coil 'F' primary/secondary circuit. The ignition coil for cylinder 6 has an electrical fault. WrenchFair's published fair-price range for this repair is $40–$150 parts and $50–$150 labor at independent shops.
WrenchFair rates P0356 a 2-of-5 DIY difficulty (“Swap the coil with another cylinder.”) with a “Diagnose soon” driveability rating: If the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 776 factory bulletins on file for this vehicle (mostly Equipment, Structure, Electrical System) — see the latest ones
On your 2005–2015 Toyota Tacoma (4.0L V6 (1GR-FE)) — Spark plugs and ignition coils:Owner-verified
Remove the plastic V-bank/engine cover. Passenger-side bank: unplug each coil connector, remove the 10mm coil bolt, pull the coil, and the plug is directly accessible. Driver-side bank: the three coils sit UNDER the intake air surge tank (plenum) — the notorious part of this job. Remove the surge tank (T40 bolts) plus the plenum-to-intake mount hardware, throttle-body connections and breather/PCV hoses; label every hose and connector. Then the driver-side coils and plugs are accessible. Inspect the plenum gasket and replace it if damaged. Thread each new plug by hand first — the heads are aluminum and cross-threading is the classic expensive mistake here.
Do this test first: Swap coil F with another cylinder's coil
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0356 on the 2005–2015 Toyota Tacoma — but the community-sourced Spark plugs and ignition coils note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Ignition coil bolts (coil x cylinder head cover): 7 ft-lbs (10 N·m) — Factory 1GR-FE ignition service specifications.
Intake air surge tank/plenum fasteners (driver's side access): verify — Confirm against factory service info for this vehicle.
Tips
Use Denso K20HR-U11 (Toyota 90919-01235) copper plugs; the 1GR-FE calls for replacement every 30,000 miles. From the factory one bank ships with Denso and the other with NGK — if you pull one of each brand, the plugs were never changed before.
Verify plug gap 0.039–0.043 in. even on 'pre-gapped' plugs.
Anti-seize is hotly debated: NGK/Denso nickel-plated threads don't require it; if you use it, reduce torque ~20–30% to avoid over-torquing the aluminum head.
Do one bank at a time and reinstall every coil connector — forgotten coil plugs cause immediate misfire codes after the plenum goes back on.
Replace all 6 coils only if they fail; coils are individually bolted and usually outlast plugs on this engine.
Typical difficulty: Easy — based on 64 code guides for the ignition repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light (may flash)
misfire on cylinder 6
rough idle
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failed ignition coil F (most common) 3 owner notes link this repair to P0356
Damaged wiring or corroded connector
Failed coil driver in the ECM
Owner notes linked to P0356: 3 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Swap coil F with another cylinder's coil
Check the coil connector Tests: Damaged wiring or corroded connector
Test coil power and ground
Replace the coil if the fault follows it
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2005–2015 Toyota Tacoma: Spark plugs and ignition coils — test first, then buy for this job.
Expensive fork: Fuel injector, then compression test — if the misfire stays on the same cylinder after a fresh plug and a swapped coil.
The price range below is a national planning range for P0356 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$40 – $150
Labor$50 – $150
Ignition coil replacement (coil F). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0356 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →