Diagnose soonIf the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter.
The ignition coil for cylinder 2 has an electrical fault.
Key facts
P0352 means ignition coil 'B' primary/secondary circuit. The ignition coil for cylinder 2 has an electrical fault. WrenchFair's published fair-price range for this repair is $40–$150 parts and $50–$150 labor at independent shops.
WrenchFair rates P0352 a 2-of-5 DIY difficulty (“Swap the coil with another cylinder.”) with a “Diagnose soon” driveability rating: If the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 255 factory bulletins on file for this vehicle (mostly Electrical System, Equipment, Engine And Engine Cooling) — see the latest ones
On your 2006–2011 BMW 3 Series (N52 3.0L I6, N54 3.0L twin-turbo I6) — Spark plugs and ignition coils:Owner-verified
Remove the plastic engine cover (it lifts/clips off). Coils are push-fit — no hold-down bolts: flip each connector cap upward, unplug, and pull the coil straight out of the plug well. On the N52, cylinders 5–6 sit under the strut brace: either use a 3" extension/short socket to work underneath it, or loosen the brace (E18 center bolt, E14 strut-top bolts) and slide it aside. The N54 is the painful one: its plugs sit in deep, narrow wells that a standard 5/8" plug socket will not enter — you MUST use a thin-wall 12-point 14mm socket or you will waste an hour on one plug. BMW and the plug makers say no anti-seize; torque to spec.
Do this test first: Swap coil B with another cylinder's coil
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0352 on the 2006–2011 BMW 3 Series — but the community-sourced Spark plugs and ignition coils note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Spark plugs to cylinder head (N52/N54): 23 Nm (17 ft-lb) — Do not use anti-seize per BMW/plug manufacturer; multiple owners note the aluminum head strips easily if over-torqued.
Strut tower brace to strut tower (if removed for access): 40 Nm + 60° — Per the N52 general torque table.
Tips
Work with a cold engine and thread every plug in by hand first — cross-threading an aluminum head is an expensive lesson.
N52 uses a standard 5/8" spark plug socket with 6" and 10" extensions; N54/N55 family engines need the thin-wall 12-pt 14mm socket.
Do not mix coil brands (Bosch with Bosch, Delphi with Delphi); 2007 cars with the old-revision coil design should have all six replaced together.
Read your old plugs — they tell you a lot about how the engine is running (post photos on the forums for opinions).
Spark plugs are a 'replace and go' part on these engines — no coding or registration needed.
Typical difficulty: Easy — based on 64 code guides for the ignition repair area (an area-level estimate, not this exact job).
Typical time: “The N54 is the painful one: its plugs sit in deep, narrow wells that a standard 5/8" plug socket will not enter — you MUST use a thin-wall 12-point 14mm socket or you will waste an hour on one plug.” — as written in the note. First-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light (may flash)
misfire on cylinder 2
rough idle
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failed ignition coil B (most common) 4 owner notes link this repair to P0352
Damaged wiring or corroded connector
Failed coil driver in the ECM
Owner notes linked to P0352: 4 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Swap coil B with another cylinder's coil
Check the coil connector Tests: Damaged wiring or corroded connector
Test coil power and ground
Replace the coil if the fault follows it
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2006–2011 BMW 3 Series: Spark plugs and ignition coils — test first, then buy for this job.
Expensive fork: Fuel injector, then compression test — if the misfire stays on the same cylinder after a fresh plug and a swapped coil.
The price range below is a national planning range for P0352 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$40 – $150
Labor$50 – $150
Ignition coil replacement (coil B). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0352 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →