Short trips and gentle driving only, until you know the cause. Fix before it leaves you stranded. If the check-engine light starts flashing, the engine shakes badly, or the car loses significant power, pull over safely and have it towed.
How serious is P0345?
Moderate. WrenchFair rates this one “Diagnose soon” — the car can usually get you home, but driving on it can turn a cheap fix into an expensive one. Fix before it leaves you stranded.
Will P0345 go away on its own?
The warning light can turn off by itself after clean drive cycles, but the code stays stored in the computer's memory and the fault is still there. Clearing it without fixing the cause just buys time — it will come back when the computer re-runs the self-test. Exception: a loose gas cap — tighten it and drive a few days.
The intake camshaft sensor on bank 2 has an electrical fault.
Key facts
P0345 means camshaft position sensor 'A' circuit - bank 2. The intake camshaft sensor on bank 2 has an electrical fault. WrenchFair's published fair-price range for this repair is $40–$120 parts and $80–$250 labor at independent shops.
WrenchFair rates P0345 a 3-of-5 DIY difficulty (“Bank 2 is the side opposite cylinder #1.”) with a “Diagnose soon” driveability rating: Fix before it leaves you stranded. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2003–2008 Infiniti G35 (3.5L VQ35DE V6, 3.5L VQ35HR V6) — Cam/crank position sensors: P0340/P0345/P0335, stalling, and long cranks:Owner-verified
Bank 1 cam sensor: passenger side, rear of the cylinder head. Bank 2 cam sensor: driver's side, under the throttle body area. Crank sensor: rear of the engine near the transmission bellhousing.
Do this test first: Check the cam signal on a scan tool
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0345 on the 2003–2008 Infiniti G35 — but the community-sourced Cam/crank position sensors: P0340/P0345/P0335, stalling, and long cranks note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Camshaft/crankshaft position sensor mounting bolt: verify — Do not guess this value - look it up in the G35 FSM (EM section for engine items, BR for brakes, CL for clutch) and use a torque wrench.
Tips
Failing cam or crank sensors cause stalling, long cranks, and hard starts - sometimes with no codes at all. The VQ35DE has one cam sensor per bank (P0340 = bank 1, P0345 = bank 2); on these cars bank 2 is the DRIVER'S side, which is backwards from most makes and trips up owners.
Use OEM (Nissan/Infiniti) sensors. One 2008 G35 owner replaced the crank sensor with an aftermarket part, saw the stalling return in about a week, then fixed it - briefly - with a genuine OEM sensor. Budget aftermarket sensors have a poor reputation on this job.
If codes persist after sensor replacement, suspect the wiring: inspect connectors, reference voltage, and harness continuity to the PCM before throwing more parts. The 2008 owner's stalling returned even after OEM sensors, pointing at heat-related wiring/harness issues.
The 2007-2008 VQ35HR sedans have FOUR cam sensors (intake and exhaust per bank) due to dual VVT - confirm which engine you have before buying.
Typical difficulty: Moderate — based on 841 code guides for the sensors repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light
hard start
rough running
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failed camshaft position sensor (most common) 2 owner notes link this repair to P0345
Damaged wiring or connector
Owner notes linked to P0345: 3 across 2 repairs — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 3 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check the cam signal on a scan tool
Inspect the wiring and connector Tests: Damaged wiring or connector
Replace the sensor if it doesn't respond
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2003–2008 Infiniti G35: Cam/crank position sensors: P0340/P0345/P0335, stalling, and long cranks — test first, then buy for this job.
The price range below is a national planning range for P0345 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$40 – $120
Labor$80 – $250
Camshaft position sensor replacement (bank 2). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0345 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →