Diagnose soonMisfires can damage the catalytic converter. Drive gently to a shop; if the check-engine light is flashing, stop driving.
The system that listens for harmful engine knock (pinging) isn't working properly. The computer plays it safe with reduced power until it's fixed.
Model notes: Knock sensors must be torqued to specification - they are piezoelectric microphones and mounting torque directly affects their sensitivity. Never use thread sealant unless specified.
Key facts
P0324 means knock control system error. The system that listens for harmful engine knock (pinging) isn't working properly. The computer plays it safe with reduced power until it's fixed. WrenchFair's published fair-price range for this repair is $30–$120 parts and $80–$180 labor at independent shops.
WrenchFair rates P0324 a 3-of-5 DIY difficulty (“Knock sensors are often buried under the intake manifold; the electrical test is easy but access can be miserable.”) with a “Diagnose soon” driveability rating: Misfires can damage the catalytic converter. Drive gently to a shop; if the check-engine light is flashing, stop driving. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2013–2014 Chevrolet Spark (1.2L LL0 I4) — Excessive oil consumption (emission recall 14110):Factory-documented
The recall work was PCV valve plus #4 spark plug at the dealer. If consumption continued, GM bulletin PI1321 sent techs down this path: formal oil-consumption test, then all four pistons out to inspect cylinder bores for stuck oil-control rings. For an owner, the practical check is oil level at every fill-up — this engine holds little oil and running low accelerates ring and valve damage fast.
Do this test first: Check for knock sensor circuit codes alongside - they narrow it to a specific sensor
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0324 on the 2013–2014 Chevrolet Spark — but the community-sourced Excessive oil consumption (emission recall 14110) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Spark plugs: verify — Plug torque not confirmed from a forum source — confirm against factory service info before torquing; the recall work replaced the #4 plug.
Tips
The documented failure chain: the PCV valve wears prematurely, the 1.2L starts drinking oil, oil-fouled plugs cause misfires and blown plugs, and if the oil runs low long enough the engine suffers internal damage — multiple owners needed full engine replacements.
GM's emission recall 14110 replaced the PCV valve and the #4 spark plug. If you are buying a used 2013-2014 Spark, confirm with the dealer by VIN that the recall was performed.
If consumption continued after the recall, GM's own follow-up bulletin (PI1321) says the PCV and plug may not fix it because the oil-control rings are stuck — the dealer then runs the standard oil-consumption test and, if verified, pulls all four piston assemblies and inspects the bores, with burned valvetrain components as the other possible outcome.
Watch for P0300 misfire and P0324 codes after the recall: the bulletin says to pull the #4 plug and look for oil fouling, then do a cylinder leakage test to confirm the valves are seating.
Prevention is a dipstick habit: owners reported 1 quart per 1,000 miles. On this small sump that means checking the level at every fuel stop, not every oil change.
Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light
reduced power
poor fuel economy
possible audible spark knock under load
hesitation on acceleration
loud noises from engine
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failed knock sensor (most common)
Damaged knock sensor wiring - the signal is tiny and easily corrupted
Corroded knock sensor connector
ECM knock processing fault (rare)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check for knock sensor circuit codes alongside - they narrow it to a specific sensor Tests: Failed knock sensor (most common)
Inspect wiring for chafing, especially where the harness crosses the engine
Test sensor resistance against spec
When replacing, torque to spec - over-tightening cracks the sensor, under-tightening makes it deaf
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2013–2014 Chevrolet Spark: Excessive oil consumption (emission recall 14110) — test first, then buy for this job.
The price range below is a national planning range for P0324 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$30 – $120
Labor$80 – $180
Knock sensor or wiring repair is the typical fix. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0324 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Knock sensors are often buried under the intake manifold; the electrical test is easy but access can be miserable.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →