P0324

P0324 on a 2013–2014 Chevrolet Spark: Knock control system error

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0324 on a 2013–2014 Chevrolet Spark

DIY difficulty 3/5

The system that listens for harmful engine knock (pinging) isn't working properly. The computer plays it safe with reduced power until it's fixed.

Model notes: Knock sensors must be torqued to specification - they are piezoelectric microphones and mounting torque directly affects their sensitivity. Never use thread sealant unless specified.

Key facts

☑ Before you buy parts — check these first:
On your 2013–2014 Chevrolet Spark (1.2L LL0 I4) — Excessive oil consumption (emission recall 14110): Factory-documented
The recall work was PCV valve plus #4 spark plug at the dealer. If consumption continued, GM bulletin PI1321 sent techs down this path: formal oil-consumption test, then all four pistons out to inspect cylinder bores for stuck oil-control rings. For an owner, the practical check is oil level at every fill-up — this engine holds little oil and running low accelerates ring and valve damage fast.
Do this test first: Check for knock sensor circuit codes alongside - they narrow it to a specific sensor
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0324 on the 2013–2014 Chevrolet Spark — but the community-sourced Excessive oil consumption (emission recall 14110) note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: GM bulletin PI1321 (NHTSA PDF) · owner complaints · press

Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check for knock sensor circuit codes alongside - they narrow it to a specific sensor Tests: Failed knock sensor (most common)
  2. Inspect wiring for chafing, especially where the harness crosses the engine
  3. Test sensor resistance against spec
  4. When replacing, torque to spec - over-tightening cracks the sensor, under-tightening makes it deaf

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2013–2014 Chevrolet Spark: Excessive oil consumption (emission recall 14110) — test first, then buy for this job.
The price range below is a national planning range for P0324 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$30 – $120
Labor$80 – $180

Knock sensor or wiring repair is the typical fix. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0324 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Knock sensors are often buried under the intake manifold; the electrical test is easy but access can be miserable.

Watch this repair on YouTube

Parts & tools

Spark plug & coil toolkit — what the job actually takes

Torque specs: Gasket-seat plugs: typically 20–30 Nm (15–22 lb-ft). Tapered-seat plugs: typically 11–18 Nm. Always verify against your engine’s factory spec — over-torquing strips aluminum threads.

Pro tip: Blow out the plug wells with compressed air BEFORE removing the plugs, so debris can’t fall into the cylinders.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →