Diagnose soonMisfires can damage the catalytic converter. Drive gently to a shop; if the check-engine light is flashing, stop driving.
The engine stumbles for the first few seconds after a cold start, then smooths out. The classic cause is a fuel injector that drips gasoline into a cylinder overnight.
Model notes: If the engine starts rough but smooths out within 30 seconds, suspect fuel leaking into cylinders overnight rather than ignition parts - ignition misfires usually persist when warm.
Key facts
P0316 means engine misfire detected on startup (first 1000 revolutions). The engine stumbles for the first few seconds after a cold start, then smooths out. The classic cause is a fuel injector that drips gasoline into a cylinder overnight. WrenchFair's published fair-price range for this repair is $30–$120 parts and $80–$180 labor at independent shops.
WrenchFair rates P0316 a 3-of-5 DIY difficulty (“Overnight leak-down testing takes patience; the diagnosis spans fuel, ignition, and mechanical causes.”) with a “Diagnose soon” driveability rating: Misfires can damage the catalytic converter. Drive gently to a shop; if the check-engine light is flashing, stop driving. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2020–2021 Ford F-350 (7.3L Godzilla V8) — 7.3L Godzilla misfire under load from heat-damaged spark plug wires — TSB 20-2370:Factory-documented
A plug-wire swap on the 7.3L is a 20-minute, no-tools driveway job on a COLD engine. Carry a spare wire (or set) in the truck — they are about $18-30 each and dealers were chronically out of stock.
Do this test first: Check which cylinders misfire on startup using misfire counters - one cylinder points at its injector or plug, random points at fuel pressure or battery
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0316 on the 2020–2021 Ford F-350 — but the community-sourced 7.3L Godzilla misfire under load from heat-damaged spark plug wires — TSB 20-2370 note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Spark plug wires: n/a — Press-fit boots — no torque spec; route the revised wires per the TSB and keep them clear of the exhaust manifolds.
Tips
TSB 20-2370: 2020-2021 F-Super Duty trucks with the 7.3L Godzilla built on or before September 28, 2020 can set P0300, P0316, or P0301-P0304 with an illuminated (often flashing) MIL, misfire, or lack of power. Root cause is the early plug wires' poor heat insulation — the Godzilla runs very hot, especially under load.
The classic owner story, confirmed by multiple F-350 7.3L owners: engine runs fine unloaded, then misfires hard on a grade or while towing — flashing CEL, sometimes limp mode and the A/C cutting out. Let it cool and it behaves again until the next hard pull.
Fix is the revised plug-wire set per the TSB (make sure the dealer orders the TSB part number — owners report parts counters trying to sell the old-design wire). The swap is genuinely a 20-minute, no-tools job on a cold engine, roughly $18-30 per wire.
Carry spares: owners who tow remote recommend keeping a wire or two under the back seat, since dealers were frequently out of stock and some trucks sat for days waiting on parts.
Don't confuse this with the rarer 7.3L lifter/cam failure: if new wires, plugs, and coils don't fix a persistent misfire on one cylinder, escalate to a dealer diagnosis rather than throwing more ignition parts at it.
Typical difficulty: Easy — based on 64 code guides for the ignition repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
rough running for the first seconds after cold start
check engine light after cold starts
fuel smell on startup
symptoms clear as the engine warms
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Leaking fuel injector flooding a cylinder overnight (most common - starts rough, clears up)
Worn spark plugs with weak cold-start spark 3 owner notes link this repair to P0316
Carbon buildup on intake valves affecting cold mixture
Weak battery or slow cranking reducing cold-start spark energy 3 owner notes link this repair to P0316
Incorrect engine oil viscosity making cold cranking sluggish
Owner notes linked to P0316: 4 across 2 repairs — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check which cylinders misfire on startup using misfire counters - one cylinder points at its injector or plug, random points at fuel pressure or battery Tests: Leaking fuel injector flooding a cylinder overnight (most common - starts rough, clears…
Test fuel pressure leak-down overnight: pressure that bleeds off points at a leaking injector or check valve Tests: Leaking fuel injector flooding a cylinder overnight (most common - starts rough, clears…
Pull plugs on the offending cylinders after an overnight sit - wet plugs confirm injector leak-down Tests: Leaking fuel injector flooding a cylinder overnight (most common - starts rough, clears…
Load-test the battery - marginal batteries cause exactly this symptom on cold mornings Tests: Weak battery or slow cranking reducing cold-start spark energy
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2020–2021 Ford F-350: 7.3L Godzilla misfire under load from heat-damaged spark plug wires — TSB 20-2370 — test first, then buy for this job.
Expensive fork: Fuel injector, then compression test — if the misfire stays on the same cylinder after a fresh plug and a swapped coil.
The price range below is a national planning range for P0316 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$30 – $120
Labor$80 – $180
Coils and spark plugs are the typical fix. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0316 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Overnight leak-down testing takes patience; the diagnosis spans fuel, ignition, and mechanical causes.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →