Diagnose soonIf the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter.
Cylinder 8 is misfiring - a bad coil, worn plug, or weak injector is the usual cause. A flashing check engine light means stop driving.
Key facts
P0308 means cylinder 8 misfire detected. Cylinder 8 is misfiring - a bad coil, worn plug, or weak injector is the usual cause. A flashing check engine light means stop driving. WrenchFair's published fair-price range for this repair is $40–$150 parts and $50–$150 labor at independent shops.
WrenchFair rates P0308 a 2-of-5 DIY difficulty (“Swap the coil with another cylinder first.”) with a “Diagnose soon” driveability rating: If the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 956 factory bulletins on file for this vehicle (mostly Equipment, Electrical System, Engine And Engine Cooling) — see the latest ones
On your 2014–2018 GMC Sierra 1500 (5.3L V8) — Spark plugs and ignition coils:Owner-verified
The 5.3L EcoTec3 (L83) uses coil-near-plug ignition: 8 individual coils bolted to the valve covers, each connected to its spark plug by a SHORT plug wire routed through a metal heat-shield boot — not true coil-on-plug. Driver's side cylinders front-to-back are 1, 3, 5, 7; passenger side are 2, 4, 6, 8. Most plugs are reachable from above; the rear passenger-side #8 plug (tight against the firewall) is the problem child — use a short (3.5-4 inch) magnetic swivel 5/8-inch spark plug socket over the top, or pull the flexible passenger-side wheel-well liner back for a direct angle at the #8 boot. Tools used in the Sierra-specific 1A Auto walkthrough: 8mm socket (coil bolts), hose pliers (boot removal), 5/8-inch spark plug socket and extensions. The OE plug for the 5.3L is ACDelco 41-114 (GM 12622441), pre-gapped 0.040 in. GM issued service update 14-481 for 2014 Silverado/Sierra LD 5.3/6.2L: loose plug wires at the coil or plug end cause P0300 misfires — pull and firmly reseat every wire at both ends, and reinstall the metal heat shields on the boots.
Do this test first: Swap the cylinder 8 coil with another cylinder
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0308 on the 2014–2018 GMC Sierra 1500 — but the community-sourced Spark plugs and ignition coils note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Spark plug (first install in new cylinder heads): 15 lb-ft — Dry threads; install on a cold engine to protect the aluminum head threads.
Spark plug (all subsequent installs): 11 lb-ft — Dry threads — GM torque chart lists a lower value for plugs reinstalled in used heads.
Ignition coil mounting bolt: verify — Confirm against factory service info for this vehicle.
Tips
Do NOT apply anti-seize to the ACDelco iridium plugs — they carry a factory anti-corrosion shell plating, and NGK's technical bulletin (NGKSP-0907-1R) warns anti-seize can raise actual clamping force ~20% at the same torque setting, risking over-torqued threads in the aluminum heads.
Never re-gap the fine-wire iridium 41-114 plugs; they are pre-gapped 0.040 in and the iridium tip is easily damaged.
Blow compressed air into each plug well to clear debris BEFORE removing plugs (ACDelco good-maintenance practice), and wear goggles.
Apply dielectric grease inside each boot to prevent tracking and ease future removal.
Break stubborn boots free with plug-wire pliers; replace any torn metal heat shields.
Cylinders 1, 4, 6, 7 are the Active Fuel Management (cylinder deactivation) cylinders — note their plug condition; these foul first on high-mileage trucks.
Typical difficulty: Easy — based on 64 code guides for the ignition repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light (may flash)
rough idle
hesitation
loss of power
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failed ignition coil on cylinder 8 (most common) 7 owner notes link this repair to P0308
Worn or fouled spark plug 7 owner notes link this repair to P0308
Clogged fuel injector
Low compression on cylinder 8
Owner notes linked to P0308: 7 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Swap the cylinder 8 coil with another cylinder Tests: Failed ignition coil on cylinder 8 (most common)
Inspect the spark plug Tests: Worn or fouled spark plug
Check compression on cylinder 8 Tests: Low compression on cylinder 8
Test the fuel injector Tests: Clogged fuel injector
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2014–2018 GMC Sierra 1500: Spark plugs and ignition coils — test first, then buy for this job.
Expensive fork: Fuel injector, then compression test — if the misfire stays on the same cylinder after swapping the coil and plug — not a second set of coils.
The price range below is a national planning range for P0308 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$40 – $150
Labor$50 – $150
Ignition coil and spark plug replacement (cylinder 8). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0308 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Swap the coil with another cylinder first.
🔌 Read your spark plugs This code names the unhappy system; your plugs show what the combustion actually looks like. Pull one and match it to the visual chart — how to read your spark plugs →
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →