Diagnose soonIf the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter.
Cylinder 8 is misfiring - a bad coil, worn plug, or weak injector is the usual cause. A flashing check engine light means stop driving.
Key facts
P0308 means cylinder 8 misfire detected. Cylinder 8 is misfiring - a bad coil, worn plug, or weak injector is the usual cause. A flashing check engine light means stop driving. WrenchFair's published fair-price range for this repair is $40–$150 parts and $50–$150 labor at independent shops.
WrenchFair rates P0308 a 2-of-5 DIY difficulty (“Swap the coil with another cylinder first.”) with a “Diagnose soon” driveability rating: If the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2005–2008 Ford Mustang (4.6L 3V V8) — 4.6L 3V two-piece spark plug breakage (TSB 08-7-6):Owner-verified
Plugs sit under the coil packs on top of the engine. The 2005-2008 4.6L 3V uses the same carbon-seizing two-piece plug design as the F-150's 5.4L — TSB 08-7-6 officially covers the Mustang.
Do this test first: Swap the cylinder 8 coil with another cylinder
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0308 on the 2005–2008 Ford Mustang — but the community-sourced 4.6L 3V two-piece spark plug breakage (TSB 08-7-6) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Spark plugs: verify — Confirm against factory service info for the 4.6L 3V before torquing — aluminum heads strip easily.
Tips
Follow the TSB procedure exactly: engine at room temperature (never warm), crack each plug 1/8 to 1/4 turn, soak the wells with carb cleaner or penetrating oil, let it sit, then work each plug back and forth slowly. Rushing the break-loose is what snaps them.
Have the Lisle 65600 broken-plug extractor on hand BEFORE starting. The lower shell can weld itself to the head with carbon on original 100k-mile plugs; the tapered plug design means the broken piece stays in the head for the extractor.
Replace with the revised one-piece plug design — owners confirm the updated plugs do not break on future changes. Confirm the correct Motorcraft plug for the 4.6L 3V before buying.
Blow out the plug wells with compressed air before removal so debris cannot fall into the cylinder, and check the engine build date (on the cam cover sticker) — 4.6L 3V builds before 11/30/07 are the affected range.
Budget reality from owners: anywhere from zero to all eight plugs can break, so plan the job around the extractor rather than hoping for luck.
Typical difficulty: Easy — based on 64 code guides for the ignition repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light (may flash)
rough idle
hesitation
loss of power
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failed ignition coil on cylinder 8 (most common) 7 owner notes link this repair to P0308
Worn or fouled spark plug 7 owner notes link this repair to P0308
Clogged fuel injector
Low compression on cylinder 8
Owner notes linked to P0308: 7 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Swap the cylinder 8 coil with another cylinder Tests: Failed ignition coil on cylinder 8 (most common)
Inspect the spark plug Tests: Worn or fouled spark plug
Check compression on cylinder 8 Tests: Low compression on cylinder 8
Test the fuel injector Tests: Clogged fuel injector
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2005–2008 Ford Mustang: 4.6L 3V two-piece spark plug breakage (TSB 08-7-6) — test first, then buy for this job.
Expensive fork: Fuel injector, then compression test — if the misfire stays on the same cylinder after swapping the coil and plug — not a second set of coils.
The price range below is a national planning range for P0308 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$40 – $150
Labor$50 – $150
Ignition coil and spark plug replacement (cylinder 8). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0308 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Swap the coil with another cylinder first.
🔌 Read your spark plugs This code names the unhappy system; your plugs show what the combustion actually looks like. Pull one and match it to the visual chart — how to read your spark plugs →
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →