P0307

P0307 on a 2013–2019 Mercedes-Benz GLS: Cylinder 7 misfire detected

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0307 on a 2007–2013 Chevrolet Silverado 1500 · 2014–2019 Chevrolet Silverado 1500 · 2014–2018 GMC Sierra 1500 · 2011–2021 Jeep Grand Cherokee · 2013–2019 Mercedes-Benz GLS · 2011–2018 Porsche Cayenne

DIY difficulty 2/5

Cylinder 7 is misfiring - a bad coil, worn plug, or weak injector is the usual cause. A flashing check engine light means stop driving.

Key facts

☑ Before you buy parts — check these first:
On your 2013–2019 Mercedes-Benz GLS (3.0L M276 V6 bi-turbo, 4.7L M278 V8 bi-turbo) — Spark plug replacement (M276 V6 / M278 V8): Owner-verified
Intermediate DIY: coil-on-plug layout is straightforward once the engine covers and air boxes are out of the way.
Do this test first: Swap the cylinder 7 coil with another cylinder
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0307 on the 2013–2019 Mercedes-Benz GLS — but the community-sourced Spark plug replacement (M276 V6 / M278 V8) note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: owner-verified repair tutorial - 'Mercedes GLS 450 Service BH Full Tutorial' (2017 GLS450; spark plugs chapter with tool/part list: NGK or Bosch plugs, torque wrench) · WIS procedure via MBWorld - 'Replace spark plugs' (BA15.10-P-1001-01C: spark plug to cylinder head, engine 278 in model 166)

Typical difficulty: Easy — based on 64 code guides for the ignition repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Owner notes linked to P0307: 6 across 2 repairs — these are counts of owner-written notes, not odds of fixing your car.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Swap the cylinder 7 coil with another cylinder Tests: Failed ignition coil on cylinder 7 (most common)
  2. Inspect the spark plug Tests: Worn or fouled spark plug
  3. Check compression on cylinder 7 Tests: Low compression on cylinder 7
  4. Test the fuel injector Tests: Clogged fuel injector

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2013–2019 Mercedes-Benz GLS: Spark plug replacement (M276 V6 / M278 V8) — test first, then buy for this job.

Expensive fork: Fuel injector, then compression test — if the misfire stays on the same cylinder after swapping the coil and plug — not a second set of coils. The price range below is a national planning range for P0307 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$40 – $150
Labor$50 – $150

Ignition coil and spark plug replacement (cylinder 7). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0307 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Swap the coil with another cylinder first.

Watch this repair on YouTube

Parts & tools

Spark plug & coil toolkit — what the job actually takes

Torque specs: Gasket-seat plugs: typically 20–30 Nm (15–22 lb-ft). Tapered-seat plugs: typically 11–18 Nm. Always verify against your engine’s factory spec — over-torquing strips aluminum threads.

Pro tip: Blow out the plug wells with compressed air BEFORE removing the plugs, so debris can’t fall into the cylinders.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

🔌 Read your spark plugs This code names the unhappy system; your plugs show what the combustion actually looks like. Pull one and match it to the visual chart — how to read your spark plugs →
Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →