Diagnose soonIf the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter.
Can I drive with P0303?
Can I drive with a P0303 code?
Short trips and gentle driving only, until you know the cause. If the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter. If the check-engine light starts flashing, the engine shakes badly, or the car loses significant power, pull over safely and have it towed.
How serious is P0303?
Moderate. WrenchFair rates this one “Diagnose soon” — the car can usually get you home, but driving on it can turn a cheap fix into an expensive one. If the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter.
Will P0303 go away on its own?
The warning light can turn off by itself after clean drive cycles, but the code stays stored in the computer's memory and the fault is still there. Clearing it without fixing the cause just buys time — it will come back when the computer re-runs the self-test. Exception: a loose gas cap — tighten it and drive a few days.
Cylinder 3 is misfiring - a bad coil, worn plug, or weak injector is the usual cause. A flashing check engine light means stop driving.
Key facts
P0303 means cylinder 3 misfire detected. Cylinder 3 is misfiring - a bad coil, worn plug, or weak injector is the usual cause. A flashing check engine light means stop driving. WrenchFair's published fair-price range for this repair is $40–$150 parts and $50–$150 labor at independent shops.
WrenchFair rates P0303 a 2-of-5 DIY difficulty (“Swap the coil with another cylinder first.”) with a “Diagnose soon” driveability rating: If the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 434 factory bulletins on file for this vehicle (mostly Electrical System, Equipment, Power Train) — see the latest ones
On your 2013–2019 Ford Escape (1.5L EcoBoost I4, 1.6L EcoBoost I4, 2.0L EcoBoost I4) — EcoBoost coolant intrusion (misfire + coolant loss):Owner-verified
No teardown needed to diagnose. Watch the coolant reservoir over a week of normal driving, pull the spark plugs and look down the bores with a cheap borescope, and pressure-test the cooling system. The failure lives between cylinders 2 and 3 on the open-deck block.
Do this test first: Swap the cylinder 3 coil with another cylinder
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0303 on the 2013–2019 Ford Escape — but the community-sourced EcoBoost coolant intrusion (misfire + coolant loss) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Engine replacement fasteners: verify — Engine replacement is not a DIY torque procedure — confirm all specs against factory service info if the long block is installed outside a dealer.
Tips
Learn the signature pattern before spending a dollar: coolant level dropping with no puddle under the car, rough idle on cold starts that smooths out, white exhaust smoke, and misfire codes (often cylinder 2 or 3). A 2018 1.5L owner at 22,000 miles went in expecting a coil and came out with an engine replacement — the dealer found coolant in cylinder 2 and indentation on the block.
Do not chase this with spark plugs and coils. Multiple owners and Ford's own bulletins confirm the root cause is the open-deck block design: cooling slits between the cylinders warp, the head seal fails, and coolant enters the combustion chamber. New plugs will not fix a cracked sealing surface.
Ford's documented fix is an engine replacement, not a gasket. TSB 19-2346 (2.0L) and TSB 22-2229 (2015-2018 2.0L applications) call for a long-block assembly; out-of-warranty owners report $6,000-$8,000. Stop-leak products will not seal a warped deck and risk clogging the cooling system.
Check your VIN for open service programs and recalls before paying out of pocket — coverage has varied by year and program. NHTSA's Office of Defects Investigation is evaluating a defect petition on these engines and class-action lawsuits are active, so keep every repair order and invoice.
A 2020 1.5L three-cylinder owner documented the same failure mode (coolant in cylinder 3, scored cylinder walls, block distortion) ending in a long-block replacement after the short block went on indefinite backorder — so 4th-gen 1.5L owners should watch coolant level just as closely.
Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light (may flash)
rough idle
hesitation
loss of power
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failed ignition coil on cylinder 3 (most common) 38 owner notes link this repair to P0303
Worn or fouled spark plug 38 owner notes link this repair to P0303
Clogged fuel injector 3 owner notes link this repair to P0303
Low compression on cylinder 3 6 owner notes link this repair to P0303
Owner notes linked to P0303: 50 across 4 repairs — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Swap the cylinder 3 coil with another cylinder Tests: Failed ignition coil on cylinder 3 (most common)
Inspect the spark plug Tests: Worn or fouled spark plug
Check compression on cylinder 3 Tests: Low compression on cylinder 3
Test the fuel injector Tests: Clogged fuel injector
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2013–2019 Ford Escape: EcoBoost coolant intrusion (misfire + coolant loss) — test first, then buy for this job.
Expensive fork: Fuel injector, then compression test — if the misfire stays on the same cylinder after swapping the coil and plug — not a second set of coils.
The price range below is a national planning range for P0303 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$40 – $150
Labor$50 – $150
Ignition coil and spark plug replacement (cylinder 3). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0303 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Swap the coil with another cylinder first.
🔌 Read your spark plugs This code names the unhappy system; your plugs show what the combustion actually looks like. Pull one and match it to the visual chart — how to read your spark plugs →
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →