Diagnose soonFuel starvation causes power loss under load and can strand you. Diagnose soon.
The electrical circuit powering your fuel pump has a fault. If the pump isn't getting power, the car won't start or will die suddenly.
Model notes: Many vehicles have an access panel under the rear seat for the pump - check before dropping the tank. And a pump that dies right after running the tank dry is no coincidence; fuel cools the pump.
Key facts
P0230 means fuel pump primary circuit malfunction. The electrical circuit powering your fuel pump has a fault. If the pump isn't getting power, the car won't start or will die suddenly. WrenchFair's published fair-price range for this repair is $30–$500 parts and $150–$500 labor at independent shops.
WrenchFair rates P0230 a 3-of-5 DIY difficulty (“Fuse and relay checks are easy; pump replacement often means dropping the tank or accessing a hatch under the rear seat.”) with a “Diagnose soon” driveability rating: Fuel starvation causes power loss under load and can strand you. Diagnose soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 610 factory bulletins on file for this vehicle (mostly Equipment, Electrical System, Structure) — see the latest ones
On your 2018–2024 Toyota Camry (2.5L 4-cyl (A25A-FKS)) — Fuel pump replacement:Owner-verified
No tank drop needed: the XV70 has a rear floor service hole cover under the rear seat cushion. Remove the rear seat cushion assembly, then peel off the rear floor service hole cover (it is sealed with butyl tape) to expose the fuel suction tube with pump and gauge assembly. Disconnect the fuel pump electrical connector, then the fuel return/main tube joints — release the tube joint clips, pull the joints off by hand, do not scratch the O-rings, and do not bend, twist, or kink the nylon tubes; cap disconnected joints with a plastic bag. Mark the assembly's paint alignment to the tank before removing the fuel pump gauge retainer, which can require up to 200 N·m (148 ft-lbf) to break loose (SST, a two-person job). Do not bend the fuel sender gauge arm when lifting the assembly out, and replace the fuel suction tube set gasket. Reassembly is done by aligning the copied start-of-threads and fully-tightened marks, not by a torque figure.
Do this test first: Listen for the pump hum at key-on - silence points at power delivery
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0230 on the 2018–2024 Toyota Camry — but the community-sourced Fuel pump replacement note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Fuel pump gauge retainer: verify — Breakaway torque can reach 200 N·m (148 ft-lbf); retainer is tightened by aligning the start-of-threads and fully-tightened marks per the repair manual. Confirm against factory service info.
Fuel suction tube set gasket: verify — Replace with a new gasket on reassembly. Confirm against factory service info.
Tips
Run the tank down near empty before starting — the in-tank assembly lifts straight out and a full tank makes spillage and handling much harder.
Depressurize the fuel system (pull the F/PMP fuse and run the engine until it stalls, or relieve pressure at the rail) before disconnecting the tube joints.
The 2018–2019 Camry 2.5L (A25A-FKS) was included in Toyota's 2020 fuel pump recall — check whether your car already got the updated pump assembly under recall before buying parts.
The whole assembly (pump + integrated level sending unit) is typically replaced as a unit on this car; a pro-tech time of about 1 hour is common, with Denso as the OEM pump maker.
Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).
Typical time: “The whole assembly (pump + integrated level sending unit) is typically replaced as a unit on this car; a pro-tech time of about 1 hour is common, with Denso as the OEM pump maker.” — as written in the note. First-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
no-start
engine dies and won't restart
no fuel pump hum at key-on
check engine light
fuel pump runs with key on
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Blown fuel pump fuse (most common - check first)
Failed fuel pump relay
Failed fuel pump drawing excessive current
Damaged wiring to the pump, especially at the tank
Owner notes linked to P0230: 9 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Listen for the pump hum at key-on - silence points at power delivery
Check the fuel pump fuse and swap the relay with an identical one Tests: Blown fuel pump fuse (most common - check first)
Test for power and ground at the pump connector
If power reaches the pump but it does not run, the pump is dead
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2018–2024 Toyota Camry: Fuel pump replacement — test first, then buy for this job.
The price range below is a national planning range for P0230 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$30 – $500
Labor$150 – $500
Filter is cheap; fuel pump replacement is moderate to expensive. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0230 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Fuse and relay checks are easy; pump replacement often means dropping the tank or accessing a hatch under the rear seat.
Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →